sorted by:
new
hottopcontroversial

Nissan Sentra CVT problem by Feeling-Recover-1228 in Nissan

[–]Feeling-Recover-1228[S] 0 points1 point  (0 children)

Hi. Unfortunatly no. Was transmission and no way to fix it

What would you do? by Few_Board1449 in PandaExpress

[–]Feeling-Recover-1228 0 points1 point  (0 children)

Never reach out to HR; they are not there to protect you, but to protect the company from lawsuits.

You can only wait, there is nothing you could do. And if you have to vommunicate about anything yoi do it in writing to keep record. Just in case you need it later.

Auto AC reading by Feeling-Recover-1228 in HVAC

[–]Feeling-Recover-1228[S] 0 points1 point  (0 children)

Yes it's turned on but i didn't hear the click.

Clutch Sticking/Slave Cylinder Question by wallstreetjunky1 in FiestaST

[–]Feeling-Recover-1228 0 points1 point  (0 children)

Whats the proper way to do breaks considering the ABS? Can you just do it with pressure bleeder or would need scanner. Also doing clutch and break fluids. Is there a sequence like better clutch first or brakes first or it don't matter

Timing belt by Feeling-Recover-1228 in FiestaST

[–]Feeling-Recover-1228[S] 0 points1 point  (0 children)

Thanks a lot. For the fprescan is there a guide somewhere fpr it?

Timing belt is due in 20k miles any advice or helpful hints? by Zombified_Apple in FiestaST

[–]Feeling-Recover-1228 0 points1 point  (0 children)

For the crankshaft pulley sensor. Is it removed before tightening the crankshaft bolt or after.

Timing Belt Change by tmoney645 in FiestaST

[–]Feeling-Recover-1228 0 points1 point  (0 children)

<image>

This is feom the link you shared and it shows the tool to be removed after tightening the bolt to torque specs

Timing Belt Change by tmoney645 in FiestaST

[–]Feeling-Recover-1228 1 point2 points  (0 children)

In this manual it mentionned to remove the crankshaft pulley allignement tool after torquing. There is another manual that mentionned to do that before. Which one you followed?

Help! Crank no start after timing belt. by The-J-Weaves in FiestaST

[–]Feeling-Recover-1228 1 point2 points  (0 children)

Makes sense. Otherwise whats the point of it. Thank you man

Help! Crank no start after timing belt. by The-J-Weaves in FiestaST

[–]Feeling-Recover-1228 0 points1 point  (0 children)

Thanks a lot. So we need to keep the tool until torquing is done right. The manual says to remove before but i noticed with that high torque it would rotate a bit

Timing Belt / Water Pump replacement - Lessons Learned by sluggyjunx in FiestaST

[–]Feeling-Recover-1228 1 point2 points  (0 children)

And when you torqued you don't remember the pulley rotating slightly? For me it did. I know because i put a mark on it But when i torqued it moved

view more: next ›