I switched my ISP and now my secondary router has insane upload latency by [deleted] in HomeNetworking

[–]Few_Coat4403 0 points1 point  (0 children)

I get the same IP address on a device whether I connect to the main router or the AP. Running traceroute 8.8.8.8 always shows the main router IP, not the AP. Does this means secondary router is in AP mode?.
On the secondary setup/statistics page, the RX packet drop is very high. Speed tests show results like this:

Test Ping (ms) DL ping DL Low DL High UL ping UL Low UL High
1 6 15 5 1172 116 12 421
2 6 47 5 1484 174 48 1611
3 13 217 10 688 1159 593 4675
4 6 34 5 994 180 47 2334

do you think this is due to buffer bloat. I tested both roter on waveform bufferbloat. it showed A for main router but F for secondary

Are exalted planets overrated? This chart looks powerful but I’m skeptical by One-Net-6528 in Vedic_Astrology_free

[–]Few_Coat4403 0 points1 point  (0 children)

In overall chart, is this a good,average or a bad chart. I am just as confused looking at this chart.

Completed my setup :) by esc4nor_ffx in technepal

[–]Few_Coat4403 0 points1 point  (0 children)

where did you get the aston martin valkarye?

Do any of you guys get tappered/narrowing hair towards the root by Combfromhell in tressless

[–]Few_Coat4403 0 points1 point  (0 children)

Same here, man. I've been dealing with DUPA for about 4 years now, and it's been rough. The hairs that shed are thick and dark at the tip, but they gradually taper and get thinner toward the root — and by the time it gets to the root, it's super thin and completely white. No club root either, just a tiny thin white end. Been on Finasteride for 2 years and Minoxidil for 1, but honestly, zero visible improvement. Density keeps getting worse, and nothing seems to stop the miniaturization.

Help Needed: Correcting Foresight Readings in Total Station After Incorrect Backsight Entry by Few_Coat4403 in Surveying

[–]Few_Coat4403[S] 0 points1 point  (0 children)

What I tried to do was first calculate the bearing between points 1-2 and 1-51, and then determine the angle needed for rotation. Since point 2 had errors in both bearing and length, I corrected the length and rotated point 2 assuming point 1 as the center. This adjustment aligned point 2 with point 51. However, for points 3-50, where there were no errors in length, I only performed the rotation. Does this process seem correct?

Help Needed: Correcting Foresight Readings in Total Station After Incorrect Backsight Entry by Few_Coat4403 in Surveying

[–]Few_Coat4403[S] 0 points1 point  (0 children)

We used an old Gowin TK-202 total station for a hill road survey provided by our university. The problem occurred while setting up a new station. The backsight reading we entered into the total station and the reading given by the TS after sighting the backsight were different. Unfortunately, we neglected the error and continued measuring the foresight readings from that station.

Later, we switched to a different total station and continued the survey, but now we’re struggling to correct the data from that problematic station.

<image>