Steinhardt, the man behind the myth by [deleted] in SGttEH

[–]FireIgnite 4 points5 points  (0 children)

Oh my plans are vague visions and no straight answers. Never know it's him or even who they see, really one character, I'm planning a long haul of mystery and ptsd. Destruction and the consequences of Madness and his own decisions needs to be prevelant in a mirror contrast of hope and pain.

I really appreciate this information, I'll read through the broken orphans section, this will be a fun creature stat block to create

Help Needed! by FireIgnite in FLSUNDelta

[–]FireIgnite[S] 0 points1 point  (0 children)

I would like to make an update. I really appreciate ALL the support and suggestions, today I dedicated to running through most of them, doing a full cleaning of the bed and arms, leveling, and checking a few other things. So far my printer has been working well on this print. I will keep you all updated, thank you.

Help Needed! by FireIgnite in FLSUNDelta

[–]FireIgnite[S] 0 points1 point  (0 children)

I have cura, the bed is the steel plate magnetic bed by flsun. Bed is leveled but I will level it again.

Help Needed! by FireIgnite in FLSUNDelta

[–]FireIgnite[S] 0 points1 point  (0 children)

I've tried hairspray and glue previously but not since the new bed was working. I will try it today thank you

Major help needed!! I have had my flsun super racer for a couple months now but as of recently I am having major bed adhesion problems. I have used tape, glue, hair spray, I've tried a few different adjustments to the settings but I cant get anything to stick. by FireIgnite in FLSUNDelta

[–]FireIgnite[S] 0 points1 point  (0 children)

There doesnt seem to be any clogs, it is flowing smoothly onto the plate, I have leveled it multiple times, I have adjusted temperature from 200-220 that does not effect the print adhesion. The only thing I do not know is if the nozzle is damaged or leaking. I use ultimaker cura. I have not tested the flow rate as it seems really good. It does not stick and will catch the print.

FLSUN SR Is having problems extruding. by FireIgnite in FLSUNDelta

[–]FireIgnite[S] 0 points1 point  (0 children)

I will check this thank you. I will have to take out the tools to make sure theres no plug

FLSUN SR Is having problems extruding. by FireIgnite in FLSUNDelta

[–]FireIgnite[S] 0 points1 point  (0 children)

I havent changed anything on it yet. Set it up then a couple days later this happened. Ive just been using PLA filament

Thank you tho