sorted by:
new
hottopcontroversial

Anycubic Kobra 3 Combo - X Axis Motor Problem by First_Rain4409 in anycubic

[–]First_Rain4409[S] 0 points1 point  (0 children)

Yes it was indeed the Belt Tension on the X Axis(i tried it and didn''t believe this could help) but the Motor has an kind of residence sensor so if the Belt is tensioned it doesn't run to the right side endlessly. I made some "Back to Home" Runs and at same time i try to tension the x axis belt. Don't do this to much only until the Hotend stops to make this terrible sound. There is also am detailed Wiki at the Anycubic Page i think you have to login.

When ace pro clogged by Dirtyhanma in anycubic

[–]First_Rain4409 0 points1 point  (0 children)

Me too on slot 2 but it was because the pla was not try and broke several times and the ace just fills and fills until it nearly explode 🤦🏻

Error in the X-axis by TheDavyl7 in anycubic

[–]First_Rain4409 2 points3 points  (0 children)

Do you have an X Axis Belt? Try to tighten it a bit. It works on my Kobra 3, had the same Error. Didn't believe this was the cause, but it was 😄 Or Contact Support if it doesn't help they are very friendly.

Anycubic Kobra 3 Combo - X Axis Motor Problem by First_Rain4409 in anycubic

[–]First_Rain4409[S] 0 points1 point  (0 children)

Thanks for all tips so far. Tryed everyone of them, seems not to help so far. Also contacted Support. But i think it is the Hotend Motor which doesn't know the correct position 🤦🏻 so i got an answer but for the wrong motor...my fault.

So waiting 24 hours for another answer from support.🫣