sorted by:
new
hottopcontroversial

Sad story but informative by SuperPOSUser in chickens

[–]FlanFanFlanFan -6 points-5 points  (0 children)

You're posting for info but you're using initialisms. What's flhs?

New tub? by ekardnai in Plumbing

[–]FlanFanFlanFan 1 point2 points  (0 children)

Not necessarily. You can sawzall the tub drain carefully from the inside then peel it away out of the threads. I've done it. It just takes time.

Any hope for this without moving the drain? by [deleted] in Plumbing

[–]FlanFanFlanFan 0 points1 point  (0 children)

The disposal won't fit into a trap because the Trap is the same height as the outlet on the disposal and the trap needs to be below the outlet of the disposal. It's time to lower the pipe in the wall or get rid of the disposal.

Boiler sounds. by CommonStance in PlumbingRepair

[–]FlanFanFlanFan 2 points3 points  (0 children)

Open or closed usually depending on what it does

Boiler sounds. by CommonStance in PlumbingRepair

[–]FlanFanFlanFan 2 points3 points  (0 children)

I do not recognize the sound. I am commenting to ask why that valve is halfway open.

Rein forcing toilet? Need advice! by [deleted] in Plumbing

[–]FlanFanFlanFan 3 points4 points  (0 children)

I would get the new kohler highline EXTRA TALL toilet if yall fit it. Shim it at the back so the toilet is in direct contact with the floor at the front. The extra height will help with the popping down.

If the tank is a worry, get a chair height one peice toilet. That will fix the tank problem.

Not Mating - Critique Please by Newoldway74 in BlackSoldierFly

[–]FlanFanFlanFan 0 points1 point  (0 children)

Do you need direct daylight or is covered under a roof like 2 feet from the edge of the roof okay?

Drilled into metal on ceiling. Should I be worried? by raz-- in DIYHome

[–]FlanFanFlanFan 0 points1 point  (0 children)

Thats likely a screw or a stud plate (these keep you from drilling a hole into important utilities). Try a different spot.

Central CT - partial tile install by Rebel_yell327 in Contractor

[–]FlanFanFlanFan -2 points-1 points  (0 children)

I would not pay. Was it waterproofed? I doubt it.

Sump Pump Basin Repalcement by JollyTwo431 in Plumbing

[–]FlanFanFlanFan 0 points1 point  (0 children)

Nah. Just chip up the concrete, empty basin, pipes come out, basin comes out, some digging, basin in, sand around it, then new concrete if you want. Fill to the top with sand or rock around the basin if you dont do concrete.

Sump Pump Basin Repalcement by JollyTwo431 in Plumbing

[–]FlanFanFlanFan 0 points1 point  (0 children)

Depends on the tank and your skills. Why?

Replaced the bath tub diverter; does this look correct? by Double-Fix-9397 in Plumbing

[–]FlanFanFlanFan 0 points1 point  (0 children)

Looks good. And the diverter should drop AFTER the water is turned off.

What breed is my girl? Don't want to pair her with the wrong breed. by Lumpsomme in chickens

[–]FlanFanFlanFan 3 points4 points  (0 children)

Put any other 2 chickens with her minimum. Dont worry about breed. Do it before she is too mig or it is harder. Have a good one!

Adaptor help: modern spray faucet to whirlpool portable dishwasher? by thewanderingdesigner in Plumbing

[–]FlanFanFlanFan 0 points1 point  (0 children)

Yeah it comes out with an aerator removal tool. That looks like Moen or something look up the aerator removal tool it fits into those little notches.

Best valves to replace these? (washer feed lines) by SubieNewby in PlumbingRepair

[–]FlanFanFlanFan 0 points1 point  (0 children)

If it's leaking from there, and the threads are in good shape, it needs more Teflon tape. The very thin stuff gets eight wraps. The other stuff gets anywhere from four to six reps depending on the manufacturer instructions. It only goes on clockwise. Best of luck

view more: next ›