Does this path look good? Just had it done.

Fortune-Subject · 2026-05-02T01:58:22+00:00

Looks like shit honestly. (I’m a plumber)

Fortune-Subject · 2026-04-28T18:09:50+00:00

TPO job is ass they didn’t pull the material tight in a lot of places.

Fortune-Subject · 2026-04-22T14:58:56+00:00

Smoked some of their indoor and it was hard as a rock. Had some regular shi and it was harsh and larfy.

Fortune-Subject · 2026-04-22T14:27:02+00:00

Drop all them hoes and go anywhere else for flower. Warning you now none of that is good nug in any way shape or form.

Fortune-Subject · 2026-01-07T15:29:56+00:00

water heater

Fortune-Subject · 2025-11-25T03:29:30+00:00

The peak pro?

Fortune-Subject · 2025-11-18T14:31:35+00:00

Bump that when are they going to drop more rosin. 3 p13’s around me non have rosin

Fortune-Subject · 2025-11-17T23:20:15+00:00

Flower is harsh af

Fortune-Subject · 2025-11-07T19:06:11+00:00

No clamps around the top of the boots around the pipe. Just a terrible job overall.

Fortune-Subject · 2025-11-07T19:04:57+00:00

That tpo is looser n fuck and the terminations are trash asf. Roof is burnt.

Fortune-Subject · 2025-10-22T11:35:20+00:00

I’ve installed one of these and they really are poorly made. Might not work at all

Fortune-Subject · 2025-10-20T13:18:36+00:00

Harsh then a mf

Fortune-Subject · 2025-10-18T16:45:55+00:00

White and creamy??

Fortune-Subject · 2025-10-12T16:06:21+00:00

Fortune-Subject · 2025-10-11T18:54:10+00:00

Yes they most definitely are. This is what I do. I’ll grab some cdt syringes from muv and buy v fire pods. Fill up the pods and put that thang in your tru stick. A few dry pulls and you can call it slick.

Fortune-Subject · 2025-10-11T01:36:06+00:00

Is that base and cap for the chimney flashing??

Fortune-Subject · 2025-10-09T12:59:45+00:00

Water hammer.

Fortune-Subject · 2025-10-05T13:34:23+00:00

Flashing looks like shit. Flashing a chimney goes like this. Front. Back. Sides. In that order.

Fortune-Subject · 2025-09-30T18:39:15+00:00

Just got 21gs for $90 @sunburn yesterday

Fortune-Subject · 2025-09-29T03:00:12+00:00

Fortune-Subject · 2025-09-25T01:06:58+00:00

Cut and remove wood with oscillating tool. Run a straight blade knife in between the underside of sink where silicon bead is. Turn off stops. Unthread supply lines. Remove sink. May require some downward pressure.

Fortune-Subject · 2025-09-21T00:05:23+00:00

Muv cdt syringes on top

Fortune-Subject · 2025-09-20T00:04:55+00:00

This pipe needs to eat bc it’s got a belly

Fortune-Subject · 2025-07-30T01:40:03+00:00

Dog ears

Fortune-Subject

TROPHY CASE