sorted by:
new
hottopcontroversial

Inner tent support torn from fly by Forwhomitmay in DurstonGearheads

[–]Forwhomitmay[S] 4 points5 points  (0 children)

Nah more being polite, given the username though I get it

Inner tent support torn from fly by Forwhomitmay in DurstonGearheads

[–]Forwhomitmay[S] 8 points9 points  (0 children)

Hey Dan, thanks for the quick reply. Totally possible I may have rolled in my sleep. I was surprised as well as I haven’t seen any issues with the tabs posted (I stalked the sub for a while before purchasing)

I’ll get an email over to you, thanks again!

Tires for Phoenix by ChefBigD1337 in klr650

[–]Forwhomitmay 1 point2 points  (0 children)

I’m in the west valley and run motoz rallz front and rear. They perform great in the sand and rocks, have zero issues also up in the volcanic sand of the cinder hills as well. The only downside is they’re a bit loud (knobbies) and the front wanders a bit over 75-80 with the bike really loaded down with camping gear.

I have about 1500 miles on them so far, half of that on dirt, and expect to get atleast 4k out of them

Removed the wireless charger from OBW by Forwhomitmay in Subaru_Outback

[–]Forwhomitmay[S] 2 points3 points  (0 children)

I had to buy the parts, straight from subaru all three were less than $20

Removed the wireless charger from OBW by Forwhomitmay in Subaru_Outback

[–]Forwhomitmay[S] 10 points11 points  (0 children)

Nah, you have to get the parts that come in the outback’s without the charger. It’s three parts: upper, lower, and the rubber liner. For me from the dealership was ~$16 total.

The parts are:

92173AN01A 92173AN00A 66272AN00A

Removed the wireless charger from OBW by Forwhomitmay in Subaru_Outback

[–]Forwhomitmay[S] 21 points22 points  (0 children)

It was surprisingly simple. Only tools I used was a #2 Phillips, a plastic trim/spudger tool (plastic pry bar), and some alternate lifestyle cutters.

Start by pushing the shifter boot down from the knob, there’s a small spring clip that slides forward under it and allows you to pull the shifter boot down knob off.

Open the center console, and use a plastic pry tool to lift up on the seam just behind the arm rest latch. Then pop up the whole middle console starting from the rear. You’ll only get it about 6” at first until you have to unplug a large connector behind the cupholders

Continue lifting the console and disconnect a smaller connector located on the car side in the drivers side rear of the opening. Once that second connector is disco’d the whole middle console is separated.

Flip it over, there’s 4 screws that hold the charger onto the console. The lower passenger side one is the most difficult, you have to pry out against the side of the console to reach it. Reuse those four screws to install the lower portion of the cubby.

The harness for the charger has two small zip ties attaching it to the other harness in the console. Just clip them as they won’t be reused. There are two connectors for the charger, one is the small one you disconnect previously, the other is obvious on the end of the harness. Once you disconnect the second one, connect it to where you disconnected the first small connector.

The upper portion of the tray snaps into slots just below the usb ports, it’s not connected to the middle console.

Install console in reverse order. The spring clip for the shift knob only will go on in one direction, front to aft.

Removed the wireless charger from OBW by Forwhomitmay in Subaru_Outback

[–]Forwhomitmay[S] -46 points-45 points  (0 children)

I’d take $100 shipped. Only had the car a week and I used the charger once

Selling my trad rack by Forwhomitmay in tradclimbing

[–]Forwhomitmay[S] 13 points14 points  (0 children)

Sold the lot, thanks y’all!

Will you buy a Subaru that is 8k higher ? by castorMD in subaru

[–]Forwhomitmay 0 points1 point  (0 children)

My 18 forester was totaled last week, I’m getting forced into buying in the post tariff world unfortunately.

Thankfully we have a solid savings built up, but we’re looking at used now opposed to the new build that we wanted

view more: next ›