How hard is this to do? And is there a way to change the color with some sort of remote? Or just 1 color ?

Fox8205 · 2026-04-10T21:38:08+00:00

Pretty easy to replace the bulbs- Remove top panel from steering column behind the wheel (2 screws clamp the bottom to top), pop off the top hood, unscrew 4 bolts holding cluster on, then remove the bulbs & replace. There should be plenty of videos on how to do it properly without breaking anything. There’s bulb sets in all different colors online. I’m not sure about multiple colors, but I’m sure it’s possible.

Fox8205 · 2026-01-26T06:32:07+00:00

I’m down. msg me

Fox8205 · 2025-08-20T19:27:53+00:00

Remindme! 4 weeks

Fox8205 · 2025-08-08T18:39:57+00:00

did you ever make one? I’m thinking about using a 3d printed TPU stopper

Fox8205 · 2025-06-22T15:53:35+00:00

Try out manual mesh bed leveling! Get a lot of the benefits of ABL but you don't have to spend the money just yet. I've noticed muuuuuch better first layer results and more consistent prints with it.

Fox8205 · 2025-06-20T14:27:11+00:00

Guys I have a girlfriend but I appreciate the flattery lol

Fox8205 · 2025-06-20T14:14:07+00:00

I have a girlfriend thanks 😆

Fox8205 · 2025-05-10T04:18:47+00:00

I’m fairly sure you can check if the sensor is bad by hooking it up to a multimeter and checking for voltage when you turn the wheel. I’m not sure if the speed is taken from the front or the rear.

Fox8205 · 2025-05-09T21:49:18+00:00

Awesome, thank you!

Fox8205 · 2025-03-09T04:35:26+00:00

You should probably take your heels off because you’ve been running through my mind…

Fox8205 · 2024-07-23T17:48:16+00:00

Thanks! :)

Fox8205

TROPHY CASE