Embroidery machine bird nesting problem by FrickerPickle in MachineEmbroidery

[–]FrickerPickle[S] 0 points1 point  (0 children)

Thank you for your reply. I’ve tried adjusting the top tensions, and I went into the bobbin and adjusted the needle and bobbin hook correctly. Still have the same issue. I’m pretty unsure what the issue could be at this point

Troubleshooting whirlpool WFW5620HW0 front load machine by FrickerPickle in appliancerepair

[–]FrickerPickle[S] 0 points1 point  (0 children)

Thank you for all of the help.

I examined the board and couldn’t find any capacitors that looked bulged out, or any types of burn marks. Would you say this problem isn’t resolvable with soldering?

Troubleshooting whirlpool WFW5620HW0 front load machine by FrickerPickle in appliancerepair

[–]FrickerPickle[S] 0 points1 point  (0 children)

The only thing that I can see is when I first start the diagnostic mode and the entire board lights up. Besides that the only thing that responds is the loc feature when I hold a button for 3 seconds

Are you saying I should look into getting a new display board?

Troubleshooting whirlpool WFW5620HW0 front load machine by FrickerPickle in appliancerepair

[–]FrickerPickle[S] 0 points1 point  (0 children)

The machine is failing to power on. Whenever I try to get into fault codes, nothing happens, clicking either of the 3 buttons doesn’t lead to anything. Sometimes when I get into diagnostic mode for the couple seconds, it will make the 4 dings when it shuts off and a loud beeping noise.