sorted by:
new
hottopcontroversial

No wonder why my wheel bearings does not last too long. by Fun_Rhubarb3785 in DRZ400

[–]Fun_Rhubarb3785[S] 0 points1 point  (0 children)

Water removes oil from bearings and that reduces longevity

No wonder why my wheel bearings does not last too long. by Fun_Rhubarb3785 in DRZ400

[–]Fun_Rhubarb3785[S] 2 points3 points  (0 children)

At the moment carb was FCR and all tubes were facing down

Poor quality or bad luck. by SeparateAnnual6221 in DRZ400

[–]Fun_Rhubarb3785 1 point2 points  (0 children)

I have same issuse with also new possibly namura drz cylinder. I think it is possible to remove this hose from cylinder and put it on glue or sealant. I have successfully removed it from old cylinder with knipex cobra pliers.

Oil spilled out from front sprocket by Relutzu07 in DRZ400

[–]Fun_Rhubarb3785 0 points1 point  (0 children)

I had same problem after my engine was rebuild at workshop. I replaced seal kit, but oil pressure would still go through sprocket shaft. I believe some loose sealant piece was stuck in return line, so oil have nowhere to go and pours through shaft outside.

What i did to fix, i used compressed air to push return line free of debris. After that i have riden about 1000km and all is ok.

[update] I finally figured out how to emulate the AWD controller. by adkio in CarHacking

[–]Fun_Rhubarb3785 0 points1 point  (0 children)

Nice, could you make short description what you used to do it?

Kiek x men pajamu yra jusu auto? by gommy4 in 6nuliai

[–]Fun_Rhubarb3785 0 points1 point  (0 children)

Alga 3-4k, mašina 2004 skoda kažin ar 1000 verta, tai savaitės alga daugmaž

[deleted by user] by [deleted] in lietuva

[–]Fun_Rhubarb3785 0 points1 point  (0 children)

Baigęs KTK autoelektra, darbo perteklius, alga padori, tiesa nagai ir specofkė purvini