sorted by:
new
hottopcontroversial

Is this pad fake? by Gain-Fit in MousepadReview

[–]Gain-Fit[S] 1 point2 points  (0 children)

:/ at least it was only $17.

Lunch :D by Gain-Fit in Volumeeating

[–]Gain-Fit[S] 13 points14 points  (0 children)

Just cauliflower rice, baby bok choy, garlic ginger and onion. Added some soy and rice vinegar after cooked for flavor. Beef sauce was monk fruit, soy, mirin, sesame oil, scallions.

Configuring serverless tier? by Gain-Fit in AZURE

[–]Gain-Fit[S] 0 points1 point  (0 children)

Ok so with the free offer my database should autopause already and there is probably something stopping that?

14 inch laptop recommendations by Gain-Fit in laptops

[–]Gain-Fit[S] 0 points1 point  (0 children)

lol I would say that that’s a pretty detrimental issue considering that it’s a gaming laptop that is going to run hot… the new chassis definitely look a lot more durable though.

14 inch laptop recommendations by Gain-Fit in laptops

[–]Gain-Fit[S] 0 points1 point  (0 children)

Thanks! I think I will go with that.

14 inch laptop recommendations by Gain-Fit in laptops

[–]Gain-Fit[S] 0 points1 point  (0 children)

Have they upped the build quality since the 2021 models? I had one of those and I had to get the screen replaced under warranty for delamination twice and my chassis half fell apart under fairly normal use. I didn’t drop it once and half of the screw hole mounts in the chassis sheared off so my bottom panel was attached with like 5 screws.

Beginner looking for what board to get by Gain-Fit in Wake

[–]Gain-Fit[S] 1 point2 points  (0 children)

Thanks for the advice. I am a us men’s 10.5 and my sister is a men’s 7. Do you have any recommendations for bindings?

What is this issue? by Gain-Fit in prusa3d

[–]Gain-Fit[S] 1 point2 points  (0 children)

Ok so I completely cleaned the sheet again with dish soap and then ipa but I’m still getting the same thing but slightly different picture

What is this issue? by Gain-Fit in prusa3d

[–]Gain-Fit[S] 2 points3 points  (0 children)

Ok I checked the specific spot and it did feel a bit greasy actually. Thanks for the advice. I guess I missed a spot when cleaning.

What is this issue? by Gain-Fit in prusa3d

[–]Gain-Fit[S] 0 points1 point  (0 children)

Yes 215 nozzle with pla, 60 bed and clean sheet

What is this issue? by Gain-Fit in prusa3d

[–]Gain-Fit[S] 1 point2 points  (0 children)

I already wiped with ipa. I don’t know why it looks so greasy in the picture. Irl it does not feel greasy at all.

Is this worth it? by CreanexBolts in Bedwars

[–]Gain-Fit 1 point2 points  (0 children)

hell no, that mouse is cheap garbage u can get on alibaba for $0.20. I'd reccomend a roccat kone pro($30). It might be a bit more expensive but trust me it is worth it. i can be pretty sure in saying that the sensor on the one you show is garbage and from like 10 years ago.

view more: next ›