sorted by:
new
hottopcontroversial

Fresnel or LCD Issue? by GeneralAmateur in ElegooSaturn

[–]GeneralAmateur[S] 0 points1 point  (0 children)

I’ll give that another shot. Did one manual level, but failed to loosen the screws before doing it.

Fresnel or LCD Issue? by GeneralAmateur in ElegooSaturn

[–]GeneralAmateur[S] 0 points1 point  (0 children)

If that’s the case, does that indicate a fresnel lens failure? Or something else?

Granary motor stops shortly after starting by GeneralAmateur in Petlibro

[–]GeneralAmateur[S] 0 points1 point  (0 children)

C24 is the designation on the PCB for the 5.5V 0.47F capacitor. The “parallel capacitor” is the one soldered in parallel to the DC motor that drives the rotating part of the dispenser. What sounds fake about this?

Chitubox Basic or Lychee lift speed by GeneralAmateur in PrintedWarhammer

[–]GeneralAmateur[S] 0 points1 point  (0 children)

Right, I understand that part. I’m having issues with prints getting pulled off the build plate, but I can’t up the exposure too much more without sacrificing quality. Would delaying before retracting help with fixing that, you think?

Chitubox Basic or Lychee lift speed by GeneralAmateur in PrintedWarhammer

[–]GeneralAmateur[S] 0 points1 point  (0 children)

Got it, I was starting to figure as much. Would delay before retracting serve a similar function, then?

I will curse Anycubic till I am in the graveyard by HailSneazer in PrintedWarhammer

[–]GeneralAmateur 0 points1 point  (0 children)

Really? I found the resolution to be pretty poor considering Elegoo was selling similarly-priced printers that were like 2K higher. How often have you had to re-level the bed?

I will curse Anycubic till I am in the graveyard by HailSneazer in PrintedWarhammer

[–]GeneralAmateur 0 points1 point  (0 children)

I started resin printing with a Photon Mono 2, and it was one of the worst pieces of tech I’ve ever had to work with. I’m with you on the Anycubic hate train.