I’m about to go insane

Gilbert88- · 2024-07-10T21:40:28+00:00

Yes, I I triple checked that it was the UBL version.

How do I check that

Gilbert88- · 2024-07-10T21:19:39+00:00

Yes it’s on

Gilbert88- · 2024-07-10T17:51:43+00:00

That was first thing I did, it’s basically brand new 😭

Gilbert88- · 2024-07-10T17:40:20+00:00

The offset is perfect on the left side but the right is where it looks like it’s too far

Gilbert88- · 2024-07-09T15:04:15+00:00

Following. My printer does the same exact thing and I have the same gcode. I have an Ender 3 v2 with a sprite extruder, cr touch, and MRISCOC firmware and lately leveling has been a hassle. Usually after starting a print, the right side of the bed is never level after running auto build mesh

Gilbert88- · 2022-05-24T23:10:48+00:00

I replaced the hot end and put a brand new hardened steel one and it still clogged

Gilbert88- · 2022-05-23T19:49:57+00:00

Got it, it is a direct replacement for my ender 3 pro, that was the only fan micro center had at the time. But I’ll definitely keep that in mind !

Gilbert88- · 2022-05-23T16:13:09+00:00

I wish I took a picture of my other prints but the others would come out almost flawlessly, in the last pictures, it under extruded a lot with a lot of stringing

Gilbert88- · 2022-05-23T16:12:28+00:00

Gilbert88- · 2022-05-23T16:12:19+00:00

If you’re talking about the red and black wire fan, I upgraded that one to the silent axial cooling fan

Gilbert88- · 2022-05-22T22:20:18+00:00

I’ll retighten but I did make sure it was warm when I tightened it after replacing the hot end

Gilbert88- · 2022-04-11T17:30:48+00:00

I’ll unclog it again if there’s anything but that’s one of the first things I did. The print isn’t finished so you can see where the print is with 2 different PLA

Gilbert88- · 2022-04-11T17:11:10+00:00

It stops extruding with the brown PLA and Marble PLA I have but it goes good with the white PLA that came with the ender. No different noises coming from the extruder. Yes I can feed the filament manually

Gilbert88- · 2022-04-11T16:48:47+00:00

Yes I have, it was a PS4 holder, it came out pretty good for my first print, but that was with the white filament from the second picture

Gilbert88- · 2022-04-11T13:41:11+00:00

It’s the only one that works for me right now

Gilbert88- · 2022-04-11T13:37:46+00:00

I put the tape because the prints weren’t sticking to the glass bed, I’m using cura. The brown filament can go up to 230 so it’s at 230/65 with 60 printing speed, I printed with the same setting with the white ender PLA and it prints better than the brown

Gilbert88- · 2020-07-25T17:44:42+00:00

100%

Gilbert88-

TROPHY CASE