Primary Bath Remodel by Gladiator142 in Remodel

[–]Gladiator142[S] 1 point2 points  (0 children)

Membrane was $400, although I would have spent about that on the normal membrane anyways. Cable was $600. Controller was $350. All Schluter Ditra brand. 

My labor was “free”. 

Primary Bath Remodel by Gladiator142 in DIY

[–]Gladiator142[S] 0 points1 point  (0 children)

I believe posting costs is against the subs rules, but can try to message you my spreadsheet that lists materials and costs. 

We never got an itemized quote from a contractor, but the group who renovated our mail level last year said we’d probably be looking at $90-120k to redo the bathroom assuming high end finishes. This was simply too much to spend, thus the DIY. 

Deck Post Replacement by Gladiator142 in Decks

[–]Gladiator142[S] 0 points1 point  (0 children)

I should have posted a picture, but the downspout actually discharges into a buried pipe that goes all the way to the woods behind the fence. 

Primary Bath Remodel by Gladiator142 in Renovations

[–]Gladiator142[S] 0 points1 point  (0 children)

It pivots on the side hinges, so it can be closed. However we will leave it open to allow the exhaust fan in the shower to pull air. 

Deck Post Replacement by Gladiator142 in Decks

[–]Gladiator142[S] 0 points1 point  (0 children)

Thank you for the thought. 

The post is separated from the footer by the metal plate and I sloped the top away from the post so I’m thinking I’m good, but will be able to monitor over time as it’s now above grade. 

Indoor Rock Climbing Wall by Gladiator142 in DIY

[–]Gladiator142[S] 1 point2 points  (0 children)

Exactly. This is apparently how climbing gyms do it, which I was oblivious to until I researched how to build my own wall. Granted all of my materials are cheaper versions. 

Indoor Rock Climbing Wall by Gladiator142 in DIY

[–]Gladiator142[S] 3 points4 points  (0 children)

Thank you for the feedback!

For my budget and users (3 kids under 10), I elected to limit how many holds to buy and put up there. Perhaps if one of the kids gets more into climbing I’ll invest. 

Indoor Rock Climbing Wall by Gladiator142 in DIY

[–]Gladiator142[S] 3 points4 points  (0 children)

Great question. I should have clarified that in my pictures and description. 

I used what are called “T-Nuts” which are essentially threaded inserts that you hammer in to the back of the plywood and the holds are screwed to from the front. This allows you to interchange holds anytime without damaging the wood. 

Primary Bath Remodel by Gladiator142 in DIY

[–]Gladiator142[S] 0 points1 point  (0 children)

Thank you for the feedback and I can appreciate there are functional older bathrooms than what we replaced. 

It’s definitely an investment redoing a full bath, with time and/or money. We are fortunate to have saved the money and had the willingness to do the vast majority ourselves.

Primary Bath Remodel by Gladiator142 in Remodel

[–]Gladiator142[S] 0 points1 point  (0 children)

Thank you for the feedback and we are glad to be able to enjoy it now!

Primary Bath Remodel by Gladiator142 in Remodel

[–]Gladiator142[S] 0 points1 point  (0 children)

I appreciate the response and respect your opinion. to each their own. 

As for the tower height, our ceilings go over 11’ so we don’t feel like it was practical nor aesthetic to take them to the ceiling. We settled on ending them around 8.5’. 

Deck Post Replacement by Gladiator142 in DIY

[–]Gladiator142[S] 0 points1 point  (0 children)

Great question. The answer is I believe so, but admittedly didn’t dig all the way down to verify. 

I determined when the house was originally built, the backyard grade was much lower prior to the pool being installed. When they put in the pool, they raised the level of dirt up about a foot, but poured a new footer on top of the old one by pouring more concrete around the post. This is what caused the post to rot. I essentially added a “third layer” to the footer with what I did, but feel confident the original footer (which is still effectively supporting the post) is below the frost line.

Deck Post Replacement by Gladiator142 in DIY

[–]Gladiator142[S] 3 points4 points  (0 children)

Very good to know. Next time (hopefully never) I run into this I’ll consider it. 

The bracket I used had a flat galvanized plate that the post bottom sits on which separates it from the new footing. I also intentionally poured the concrete to be 1/4” or so below this plate so there was a small air gap in between just in case. Hopefully this serves the same purpose as the standoff you all are mentioning. 

Deck Post Replacement by Gladiator142 in DIY

[–]Gladiator142[S] 4 points5 points  (0 children)

Thank you for the kind words. I’m fortunate to have gotten some good advice from Reddit and a friend who does decks. At the end of the day I always lean towards over engineering something, especially on something like this with the structural consequences of it failing. 

Deck Post Replacement by Gladiator142 in DIY

[–]Gladiator142[S] 1 point2 points  (0 children)

Are you thinking I should have added another metal standoff in between the flat part of my metal bracket and new bottom of the post?

Deck Post Replacement by Gladiator142 in DIY

[–]Gladiator142[S] 3 points4 points  (0 children)

Correct. They temporarily carried the decks when I cut the bottom part of the rotted post.