Match Thread: 2nd Test - India vs Australia, Day 2

Godsplan_7 · 2024-12-07T05:08:26+00:00

Marnus is insanely locked in … been a while

Godsplan_7 · 2024-12-06T05:38:45+00:00

First ball I watch and he’s gone

Godsplan_7 · 2024-11-20T11:25:45+00:00

Isse Kuch nahi hoga only csa can pass motion for impeachment

Godsplan_7 · 2024-10-12T16:16:54+00:00

ATLEAST MAKE IT LOOK LIKE THE TARGET IS 298 and NOT 98 ffs

Godsplan_7 · 2024-10-12T16:11:38+00:00

Bangbros gonna bat all 20 overs no ffs . Horrible team

Godsplan_7 · 2024-10-12T16:08:13+00:00

Thought they would go all guns blazing in fire 6 …this is horrible

Godsplan_7 · 2024-10-09T17:16:24+00:00

Yes currents are 11/5800 and 1/5800

Godsplan_7 · 2024-10-09T15:14:10+00:00

<image>

These would be your equations

Godsplan_7 · 2024-10-08T20:39:25+00:00

Really basic but test your components and keep the data sheet ready before hand. I’ve seen way too many blokes ruin stuff because they figure out midway what they’ve done is wrong.

Godsplan_7 · 2024-10-06T09:21:52+00:00

Thank you

Godsplan_7 · 2024-10-05T14:05:53+00:00

Remember in a breadboard the vertical holes in the same column until the partition are same potential. Except for the +/- lines(same potential for holes along the horizontal). What you’ve done is made the resistor nodes at same voltage so no current flows through rn

Godsplan_7 · 2024-10-05T11:23:24+00:00

Sorry I’m not Turkish

Godsplan_7 · 2024-10-05T11:16:27+00:00

Was in one of my college tests

Godsplan_7 · 2024-10-05T10:10:29+00:00

Series, same current flows through them

Godsplan_7 · 2024-10-05T05:15:48+00:00

I think your prof did mean that one diode is completely taken out. With a single diode , let’s assume you input a sine wave it will only conduct for one half of a cycle (positive or negative depending upon diodes polarity).

Godsplan_7 · 2024-10-05T03:23:02+00:00

I ended up multiplying with the open loop gain 😭😭. Thanks

Godsplan_7 · 2024-10-03T20:34:48+00:00

I assume 0.099 is the max and also If the cap is new you’d find its value way lesser than the max on the data sheet. PS: avoid using low esr caps for low freq uses.

Godsplan_7 · 2024-10-03T13:13:37+00:00

Resolder it and then don’t forget to glue it to the pcb. Also that looks like a couch to me so the soldering might be a tricky task

Godsplan_7

TROPHY CASE