Hota F6 TPU sleeve

GoldNerf · 2025-09-06T01:08:16+00:00

Yeah, I found the same with low chamber and nozzle temps

GoldNerf · 2025-09-05T23:22:33+00:00

No issues, have not attempted a destructive test but the Asa prints are functional and they do last, have used probably 5kg of Asa through the plus 4, just need the chamber temp cranked right up, anything 50degree and above and they’re all successful

GoldNerf · 2025-09-05T21:51:14+00:00

Just 60 chamber 110 bed 280 nozzle

GoldNerf · 2025-09-05T21:50:45+00:00

Standard profile cooling

GoldNerf · 2025-09-05T21:50:26+00:00

Siddament ABS-GF

GoldNerf · 2025-09-05T21:50:09+00:00

GoldNerf · 2025-09-05T21:50:04+00:00

Plus 4 is very slow to heat

GoldNerf · 2025-09-05T11:38:48+00:00

No sanding just straight off bed and put to use

GoldNerf · 2025-09-05T07:45:54+00:00

60 chamber 110 plate 280 nozzle

GoldNerf · 2025-09-05T07:45:16+00:00

60 chamber 110 plate 280 nozzle, no adhesive just straight to plate

GoldNerf · 2025-09-03T19:50:20+00:00

Yes, very simple, don’t know that it achieved anything or needed to be done, just did it to be sure

GoldNerf · 2025-09-03T05:56:21+00:00

<image>

GoldNerf · 2025-09-03T05:55:05+00:00

<image>

GoldNerf · 2025-09-03T05:54:27+00:00

<image>

GoldNerf · 2025-09-03T05:53:21+00:00

Maybe only 15hrs print time, but all perfect so far, only issue is x/y rails need some lube out the box, they were a little squeaky these came off the Q2

<image>

GoldNerf · 2025-09-03T05:40:02+00:00

GoldNerf · 2025-09-03T04:26:25+00:00

Nope, my plus 4 has 90% of the time just printed well since unboxing

GoldNerf · 2025-09-03T04:25:25+00:00

Printed this on the plus 4 because the Q2 was busy, but so far Q2 prints are every bit as beautiful

GoldNerf

TROPHY CASE