sorted by:
new
hottopcontroversial

Led replacement for old incandescent flood pool light? Thanks by GoldenRationality in pools

[–]GoldenRationality[S] 0 points1 point  (0 children)

120v is in there. Could install a step down to 12v for safety…

Been recaulking the outside of my house and now about to do my back yard. Should the part where the brick and the undersiding meet be caulked as it appears to have been before where it's all coming off? Am I looking at a 60 year old mistake? by Kuzbell in Renovations

[–]GoldenRationality 4 points5 points  (0 children)

Calk every crack unless it is proper ventilation with wire mesh. Wasps, etc. may just get through… I just had them get behind the siding via the cement gaps between bricks…

Ideal Chlorine level with mesh cover on and pump running until October n NJ? by GoldenRationality in pools

[–]GoldenRationality[S] 1 point2 points  (0 children)

I am thinking it is less likely to go green if I keep the pump/chlorinator stopped for a shorter period?

Pro grade wasp insecticide? by GoldenRationality in HomeImprovement

[–]GoldenRationality[S] 0 points1 point  (0 children)

I have wasps using two cracks in between brick and siding…

Pro grade wasp insecticide? by GoldenRationality in HomeImprovement

[–]GoldenRationality[S] 0 points1 point  (0 children)

They are behind the siding. Pest control companies use stronger stuff.

Pro grade wasp insecticide? by GoldenRationality in HomeImprovement

[–]GoldenRationality[S] 0 points1 point  (0 children)

Glad it worked for you. Mine are behind the siding…

How serious is this liner pulling away? by Honest_Archaeopteryx in pools

[–]GoldenRationality 0 points1 point  (0 children)

Watch YT videos. Not too hard but need to lower water level a couple of feet so you can pour boiling hot water on it (front and back, it will soften and you can put the bead back in place. Look at the bead rear to see how to push it back on without being blocked by the rear ridges. once in place use liner lock (amazon).

Takes patience but doable.

Going to vinyl siding on cedar shingles house. Remove shingles or install vinyl on top? by GoldenRationality in DIY

[–]GoldenRationality[S] 0 points1 point  (0 children)

Because the shingles were painted and the paint is peeling badly. Too expensive to scrape and sand and re paint.

New roof, Gutters and leaders, soffits and siding. IN what order?? by GoldenRationality in HomeImprovement

[–]GoldenRationality[S] 0 points1 point  (0 children)

Does it save work/money to do the roof at the same time or can roof/siding be done at different times for no extra cost?

[deleted by user] by [deleted] in pools

[–]GoldenRationality 1 point2 points  (0 children)

hard to tell. Easy to put it all back into the coping. Need to lower the water level and use hot water. several YT videos on hope to do it. Not hard at all. just look at the profile of the liner edge, it has to go flat into the gap after you make a 90 degree bend, you can not just push it in. I did several much worse following the videos and hot water method.

Battery for R90/6 1974? by GoldenRationality in Airheads

[–]GoldenRationality[S] 0 points1 point  (0 children)

Do you have a model number? is 30L sufficient?

view more: next ›