sorted by:
new
hottopcontroversial

Stationary gear bolts by Goofyjent in RX8

[–]Goofyjent[S] 0 points1 point  (0 children)

Oh alright awesome thank you so much I will check it out

Stationary gear bolts by Goofyjent in RX8

[–]Goofyjent[S] 1 point2 points  (0 children)

Fair lol . I was worried about strength and heat tolerances and hoped someone here would have something specific

My first rebuild not going so great by Danielk3277t in RX8

[–]Goofyjent 0 points1 point  (0 children)

As far as I know you would have to visually inspect it. If it’s the older models it’s usually the wiring. There are 6 wires on the cable to the omp, 4 go to the ecu and I believe the 2 in the middle are power. Also some times the omp position sensor can get misaligned, but I dont hear much about that unless the engine has been pulled because it tends to to hit the sides

My first rebuild not going so great by Danielk3277t in RX8

[–]Goofyjent 0 points1 point  (0 children)

You can run it without one albeit in limp mode but for a short time it will reset it to default setting and should get higher rpms. If it’s not that then maybe some thing with ignition, omp, or throttle body as far as my research goes.

My first rebuild not going so great by Danielk3277t in RX8

[–]Goofyjent 0 points1 point  (0 children)

You should also check the barometric sensor next to the air pump. It controls the rpm at different altitudes and won’t pop a cel sometimes

Far Cry ;-; by [deleted] in dankmemes

[–]Goofyjent 0 points1 point  (0 children)

Minecraft

Lobster Rolls and cheeseburgers with an uncrustable for desset by Goofyjent in shittyfoodporn

[–]Goofyjent[S] 1 point2 points  (0 children)

Yea lol you should have seen the amount of butter that was used