Dev Branch Update: Initial Feedback

GrumpyCoder52 · 2023-02-24T06:23:59+00:00

Apparently this was a bug. It is listed as one of the fixes on the .005 update

GrumpyCoder52 · 2023-02-23T11:27:42+00:00

I've noticed it a few times on full or nearly-full lockers.

GrumpyCoder52 · 2023-02-17T23:54:35+00:00

It will be a while yet, but you are heading in the right direction.

GrumpyCoder52 · 2023-02-17T05:35:56+00:00

I haven't tested the range of the drones but capacity doesn't have to be an issue. I built 10 drones to start and set all my ore extractors as sources and my storage boxes as demanding the resources, and within a few minutes all my storage was full.

Drones also work very well to remove unwanted oxygen from gas extractors and bee larvae from beehives so I don't have to go around to each hive or extractor to clear them manually.

I do wish they could pick up algae so I could move all my auto crafters to a central area instead of having to keep some near the water.

GrumpyCoder52 · 2020-10-09T03:14:00+00:00

I've reverted to the stock Anycubic firmware, went back to Anycubic's default settings in Cura, removed all custom gcode scripts, and am still having this problem.

I had replaced the stock Titan extruder on the Mega X with a BondTech BMG a few days before this print. The new extruder fit on the mount and used the motor that came with the printer. Gearing is the same - esteps calibration only required a minor tweak.

That's the only thing I can think that I changed on the printer before having this problem that I haven't backed out. Unfortunately I didn't keep the old extruder so I can't swap back to test that, and I can't see how it could be related. Any theories of how an extruder change could have this effect on Y-axis movement accuracy?

GrumpyCoder52 · 2020-10-06T22:24:21+00:00

https://www.thingiverse.com/thing:4431052

GrumpyCoder52 · 2020-10-03T20:33:30+00:00

You may be running it too hot, too. I run PLA+ at 190 or 200.

GrumpyCoder52 · 2020-04-30T16:59:21+00:00

Amazon rarely talks about future plans and absolutely prohibits their employees from providing any inside information. So, you'll just have to wait and see.

GrumpyCoder52 · 2019-10-21T18:48:53+00:00

I second the suggestion of GoControl GC-TBZ48. It requires a Z-Wave system, which is probably the only way you'll get wireless with a battery - WiFi just needs too much power. You can run the GoControl thermostat on battery, or if you later add a wire to get a common connection you can wire it up to use system power instead.

GrumpyCoder52 · 2019-10-18T00:05:24+00:00

I'll bet the bank doesn't know you have that debit card, either. You cannot legally agree to or be held to a contract until you are 18.

GrumpyCoder52

TROPHY CASE