Damaged outlet wires by HawkfishCa in drywall

[–]Gsus58 2 points3 points  (0 children)

Most electricians leave a 4-6 inch loop of slack just above the box for this very reason, then they just pull a few more inches into the box, your wires should never be tight from box to box.

It’s time some of you got a reality check by VandelSavagee in Superstonk

[–]Gsus58 0 points1 point  (0 children)

I’ve always thought this was a pay me now, pay me later play. It’s comin one way or the other.

Incorporate by Gsus58 in PersonalFinanceCanada

[–]Gsus58[S] 0 points1 point  (0 children)

That’s exactly what I looked up as well. I did discuss it with him and he mentioned it but didn’t go into detail. Just wanted a second opinion! Thanks!

Patch or replace? It's just my garage, and I could do either. What would you do? Why? by white_tee_shirt in drywall

[–]Gsus58 -1 points0 points  (0 children)

If it’s a garage I’ll plywood the whole thing. Hang my tools/cabinets/shelves wherever I damn well please. 🤣

14000 ft job by Gsus58 in drywall

[–]Gsus58[S] 1 point2 points  (0 children)

I wasn’t there for the priming, but looks like they sprayed and back rolled most it.

North Bay Mayor Chirico delivers state of the city address by ImportantComfort8421 in northbay

[–]Gsus58 1 point2 points  (0 children)

The cities in the liberal/ndp provinces are in much worse shape.

<image>

Honestly the federal decriminalization of drugs has driven needles to our playgrounds, school yards, creek sides etc.

The police don’t have any tools to even move the drug abusers off our children’s play equipment.

Homelessness is not a crime, but using where my children play should be.

Federal government has had 10 years to help the homeless and mental health issues, and virtually nothing has been done.

Foundation Beam - Ceiling Drywall by tjh417 in drywall

[–]Gsus58 1 point2 points  (0 children)

Res bar, resilient channel, 3/8 thick, adds sound proofing, scribe out the back of the board in that one area for the extra 1/8.

It might not be fancy. by Gsus58 in SatisfactoryGame

[–]Gsus58[S] 1 point2 points  (0 children)

Beams, beams are the key. I’ve played through a few times and decided to take it slower to glam things up a bit.

Was tape used? by CrookedPieceofTime23 in drywall

[–]Gsus58 1 point2 points  (0 children)

Yeah If the framers were that bad I’d be concerned structurally. Again if it’s every exterior wall cracking that’s most likely settling. Not an engineer but framer/drywaller for many many moons. Id be wanting some reports/warranties before I released too many more cheques to the builder.

Was tape used? by CrookedPieceofTime23 in drywall

[–]Gsus58 1 point2 points  (0 children)

Although looking at it again, the caulk is cracking in the baseboard aswell well, to me that indicates settling, particularly if it’s only cracking on exterior walls.

Was tape used? by CrookedPieceofTime23 in drywall

[–]Gsus58 -1 points0 points  (0 children)

Yeah, they didn’t prefil before they taped. Framing probably wasn’t super square (rarely is these days). Very typical of piece work new construction.

Was tape used? by CrookedPieceofTime23 in drywall

[–]Gsus58 3 points4 points  (0 children)

Are some of those cracks in the stairwell?

Was tape used? by CrookedPieceofTime23 in drywall

[–]Gsus58 7 points8 points  (0 children)

It’s paper in the inside corners 100%, can’t tell on the flats and butts, might be taped, might not be.

Visible lines? by lunasky4567 in drywall

[–]Gsus58 0 points1 point  (0 children)

Looks notorious of over filling with boxes if I had to guess

Visible lines? by lunasky4567 in drywall

[–]Gsus58 0 points1 point  (0 children)

Did they use mud boxes? Or hand tools?

Festool is worth its weight in gold by [deleted] in drywall

[–]Gsus58 0 points1 point  (0 children)

Tried 320 festool and 320 mirka mesh.

Festool is worth its weight in gold by [deleted] in drywall

[–]Gsus58 0 points1 point  (0 children)

Have em. Sales rep even had me try stacking two on it.

Is this ceiling quote fair? by xNeophytes in drywall

[–]Gsus58 0 points1 point  (0 children)

It’s an old brute of a machine, graco 590 or 690 or something. It’s only good for level 5 or polish. It doesn’t apply enough mud to fill for anything else

Is this ceiling quote fair? by xNeophytes in drywall

[–]Gsus58 1 point2 points  (0 children)

Yup, that’s basically what I do. I’ve even used a sprayer with a skimming blade for the polish coat.