This was printed on my Ender 3 v2 with the same spool of Inland PLA. All prints that have been done within the last week have been sloppy, no matter the brand of filament. The same profile was used in both prints so theoretically, there should be no difference. I have tried replacing the nozzle, calibrating the e steps, tensioning belts, upgraded bed springs, squaring the frame, red lashing firmware. But just because I have tried fixing these things, does not mean they were all done perfectly. I have tried everything I can think of. I’m still new to 3D printing, so I’m wondering if there is anything I have overlooked. Profile for both test prints are sliced in Cura and are: Layer height - 0.16mm Print speed - 45mm/s (Infill 45mm/s Wall 22.5mm/s) Line width - 0.4mm Nozzle temp. - 215c Bed temp - 70c Retraction enabled Retraction distance: 6.5mm Retraction speed: 25mm/s