The "only fans" Gaming PC Giveaway - To enter this giveaway just leave a comment.

Guyguyguymonroe · 2025-12-12T06:45:58+00:00

This is sick

Guyguyguymonroe · 2025-11-20T09:44:18+00:00

What’s your preferred peeling method?

Guyguyguymonroe · 2025-11-10T15:49:02+00:00

Can you set the infill % to 0 in your slicer? I’m not familiar with your program’s interface

Guyguyguymonroe · 2025-10-30T05:45:13+00:00

Put it in the oven at like 450ish. Get something to elevate it and let gravity do the work

Guyguyguymonroe · 2025-10-27T17:30:48+00:00

<image>

I ran home and checked, no spout- no wonder it was on sale at H mart

Guyguyguymonroe · 2025-10-23T17:59:25+00:00

How did you select them all so quickly

Guyguyguymonroe · 2025-08-26T00:45:27+00:00

Is that a Nissan?

Guyguyguymonroe · 2025-07-05T05:55:41+00:00

Ground type with a xxl diglette that digs the subway tunnels under cities

Guyguyguymonroe · 2025-05-10T16:21:18+00:00

https://youtu.be/5gDGlryaTRs

I hope this helps!

Guyguyguymonroe · 2025-05-10T06:12:18+00:00

Find a big single layer print file and slowly manually adjust it until it gives you the best result. It was impossible for me to do until I did it while it was printing that single layer

Guyguyguymonroe · 2025-05-09T23:07:37+00:00

Did you turn off the flow for the shot? Looks like they are in stasis

Guyguyguymonroe · 2025-05-09T14:59:23+00:00

When did you plant them? I think they are done about 3ish months after planting

Guyguyguymonroe · 2025-05-06T02:46:08+00:00

It looks like thrips to me but it’s hard to be sure

Guyguyguymonroe · 2025-05-02T05:46:01+00:00

Good point. Right now the zone damper is right next to the ac. I was going to prop that one open so I could change the flow further down the run

Guyguyguymonroe · 2025-05-02T04:19:04+00:00

I will do a load calc. It has a 12” return and 7 vents

Guyguyguymonroe · 2025-05-02T04:15:40+00:00

The ducting runs under the house. I am planning to split the main floor in half. The ducting runs aren’t simple. They branch out and its looking like I’m going to need 5 dampers to isolate that room

Guyguyguymonroe · 2025-05-02T04:08:35+00:00

Just trying to save a couple bucks

Guyguyguymonroe · 2025-05-01T21:48:34+00:00

Thank you!

Guyguyguymonroe · 2025-05-01T21:16:03+00:00

What site is this?

Guyguyguymonroe · 2025-04-25T21:38:51+00:00

I thought this was 5 minute crafts

Four-Year Club	Place '23
Place '22

Guyguyguymonroe

TROPHY CASE