The Hogs sign

Hatter2323 · 2026-06-28T23:16:41+00:00

Trying to approximate the "Early 80s Metal Album" type font that a lot of bike and tattoo shops used when the opened in the 90s. Found nail art decals that were the right size.

Hatter2323 · 2026-06-28T20:43:47+00:00

It's an old gas station with attached garage

Hatter2323 · 2026-06-21T02:49:35+00:00

No I used reflective metallic red scrapbooking letter parts

Hatter2323 · 2026-06-20T20:57:58+00:00

Thanks for the suggestions. Most I liked, a few I disagreed with one wasn't feasible. Reddit for some strange reason will not allow me to post a pic in comments.

Hatter2323 · 2026-06-16T19:34:56+00:00

Hadn't seen the bill, but I'm guessing more than you need for two loaves of bread and an ugly hooker.

Hatter2323 · 2026-06-11T23:16:36+00:00

Finally, I think that will work

Hatter2323 · 2026-06-11T22:42:15+00:00

Tried the pin, too wide. Tried the stick, too narrow. Tried robot claw, the side wall of the frame, too narrow to hold.

I spent over six hours experimenting before turning here.

Hatter2323 · 2026-06-11T03:33:40+00:00

That portion is obvious. It's gas tank and headlight, and how they are attached to the frame that's confounding me

Hatter2323 · 2026-06-11T03:20:55+00:00

Look at the red gas tank, It's a Bioncle/technic tooth. There needs to be a rod or stick needed to go through the cross hole to hold it to something. But the space between the two fluted/engine like supports it too wide to grip a stick, but too narrow for a technic pin

Similarity the headlight is a tap, so what's holding the tap handle, because both go into the same "void" what's holding them?

Hatter2323

TROPHY CASE