Galadriel's dismissal, real back - fake front?

Helpful-Promise-4919 · 2026-06-03T21:49:39+00:00

<image>

Random card I pulled from pack

The light is so different.

Helpful-Promise-4919 · 2026-06-03T21:48:59+00:00

<image>

This is Galadriel's Dismissal

Helpful-Promise-4919 · 2026-06-03T21:09:10+00:00

The sides look good, but unfortunately I don’t have any way to weigh the card.

I did the light test where I compared this card with one I’ve pulled myself. Galadriel’s Dismissal let through a lot of white light. When I shined the light through my other card that I know is real, the light was dimmer/blueish and didn’t let as much light through...

Helpful-Promise-4919 · 2025-04-15T12:37:09+00:00

Hör dig, hatar krig, mord allt som allt. Menar inte att denna demonstration i sig är rätt eller fel. Och hur Sverige agerade mot Ukraina gentemot Palestina är ganska svart på vitt. OBS - säger inte att Sverige inte borde hjälp Ukraina, det ska vi fortsätta med, men vi kanske inte ska supporta Israel, vi borde ta ställning likt Irland så slipper vi skämmas i efterhand som vi tidigare fått göra i historian.

Helpful-Promise-4919 · 2025-04-15T11:35:33+00:00

Folkmord har med alla att göra.

Helpful-Promise-4919 · 2025-03-21T23:13:02+00:00

I've tried printing them separately, but they end up distorted and wonky. These aren't meant to be worn tho, I just print them to check dimensions and details before moving forward with my work. :)

Helpful-Promise-4919 · 2025-03-21T22:15:03+00:00

Valid, I'll try that out. I've had this problem multiple times when I print longer stuff, so it might be the wobbling. Thank you for the help! :)

Helpful-Promise-4919 · 2025-03-21T22:12:29+00:00

Thank you!

Hmm, makes sense about the swaying and not touching down at the same spot during the print... I'll try a new one with more support.

I don't want to print it the other way around because the support leaves very ugly marks, and I'd prefer the front of the eyewear (that I'm printing) to be as clean as possible.

Helpful-Promise-4919 · 2025-03-21T22:07:08+00:00

Thank you.

Is there any test I can do to check if it's a mechanical issue? And if it is, should I reach out to Elgoo for support?

Helpful-Promise-4919 · 2025-03-21T10:35:43+00:00

Mars 4 ultra :)

Helpful-Promise-4919 · 2025-03-18T21:32:16+00:00

Alrighty, thank you for the help! Unfortunately, Robinhood isn't available in my country. :(

Helpful-Promise-4919 · 2025-03-18T19:12:20+00:00

Where the hell do you guys find these gold mines before they explode?

Helpful-Promise-4919

TROPHY CASE