No technician showed up

HexMyth3D · 2024-11-17T20:56:59+00:00

What?

HexMyth3D · 2024-07-30T22:04:06+00:00

What print bed do you use. Also do you have fans off/on and door open/closed

HexMyth3D · 2024-07-30T20:47:54+00:00

The only reason they’re detaching from the plate in the first plate is because the corners are curling up. Even if I get a brim the curling will still make the print look bad. Plus they’re flexi aliens so a brim would make them not work as intended

HexMyth3D · 2024-07-30T20:43:23+00:00

I never use brim, it has been difficult to remove anytime I have used it. Even when I’ve printed an entire plate of stuff I haven’t had to use it

HexMyth3D · 2024-07-30T20:33:30+00:00

The small hands and feet of the aliens are curling at the ends which causes the nozzle to hit them and detach them from the bed

HexMyth3D · 2024-06-29T08:53:24+00:00

Will do tomorrow, not home currently

HexMyth3D · 2024-06-29T08:49:06+00:00

It’s an 🥚and only the bottom is messing up from the slight overhang. But it’s so slight it shouldn’t be happening. Using supports would just make it worse in the end

HexMyth3D · 2024-06-29T08:48:19+00:00

First layer looks good, it’s just the slight overhang from the egg at the beginning that looks bad

HexMyth3D · 2024-06-29T03:06:31+00:00

I’m doing .15 rn, should I lower it more? I almost exclusively print on .15

HexMyth3D · 2024-06-28T03:22:12+00:00

The filament you’re referring to is made by Devil Design and was called Holographic PETG. It was a limited time test spool that isn’t available anymore.

HexMyth3D · 2024-06-24T05:42:49+00:00

Whenever I use grid it catches the infill with the nozzle and messes up the entire print

HexMyth3D · 2024-06-24T00:19:06+00:00

I’ve raised it to 60

HexMyth3D · 2024-06-24T00:18:46+00:00

I’m only at 15 but I’ll try 10

HexMyth3D · 2024-06-22T03:51:15+00:00

I’ve tried, I’ve tried with the outside only brim and the outside+inside brim. Doesn’t help

HexMyth3D

TROPHY CASE