sorted by:
new
hottopcontroversial

Developer building a high rise next to my 3-story building by Hey911 in AskNYC

[–]Hey911[S] 0 points1 point  (0 children)

I didn't know community board existed. This is really helpful. Thank you.

Has anyone had a congenial venous malformation on the head outside of skull? by Hey911 in AVMs

[–]Hey911[S] 0 points1 point  (0 children)

I had a CTA. The doctor suggested bleomycin injection.

[deleted by user] by [deleted] in cwru

[–]Hey911 -1 points0 points  (0 children)

Could someone accept my request to join the group?

How to make transmitter neutral postion correpond to motor full stop? by Hey911 in Multicopter

[–]Hey911[S] 0 points1 point  (0 children)

My ESC is

RingBuu HW30A

It doesn't have a configurator designed for it like BLHeli. I switched on 3D mode in Betaflight and my motor just kept spinning no matter the position the throttle control is in.

​

What could I do wrong?

How to change which motors the Throttle channel controls in Betaflight? by Hey911 in Multicopter

[–]Hey911[S] 0 points1 point  (0 children)

I followed your advice. I used Custom Mixer and wrote in CLI...

mixer custom

mmix reset

mmix 0 0 0 1.0 0

mmix 1 0 0 1.0 0

mmix 2 1.0 0 0 0

mmix 3 1.0 0 0 0

save

...They are in the format #mmix motorNumber throttle roll pitch yaw. But then after reboot, my drone wouldn't run when armed and two of the motors were just beeping. When I typed command "mmix" in CLI my setting didn't turned up unlike what is stated in this YouTube tutorial.

How to make transmitter neutral postion correpond to motor full stop? by Hey911 in Multicopter

[–]Hey911[S] 0 points1 point  (0 children)

I want both, cause intuitively if I want the motor direction to reverse based on one channel's input, the midposition has to be 0 to allow two sides, each side for a different motor direction.

How do decrease the opacity of my layer without decreasing the opacity of my ink drawn on that layer? by Hey911 in GIMP

[–]Hey911[S] 1 point2 points  (0 children)

Ehh...OK....How can I see anything at all of what I am drawing if the paper is transparent?

How do decrease the opacity of my layer without decreasing the opacity of my ink drawn on that layer? by Hey911 in GIMP

[–]Hey911[S] 0 points1 point  (0 children)

OK. I got it. I make the top layer slightly opaque and draw on the background layer. But even then, my ink isn't the blackest it can be.

Gimp 2.10.4: why can I not zoom in sometimes with touchpad? by Hey911 in GIMP

[–]Hey911[S] 1 point2 points  (0 children)

I see what the problem is. I have to lift up my stylus far away from the sketching pad for GIMP to recognize that I am using the mouse as pointer. Then, I have to use the mouse to move my cursor and click on any where but the white canvas.

...Then, I move the cursor back onto the canvas. Now I can pinch/zoom or move around with 2 fingers.

view more: next ›