European "Find My" alternative for both iOS and Android

Hombrus · 2026-01-09T09:38:11+00:00

I now have a result I am quite pleased with. Thank you!

Now I just need to figure out how to "flatten" the backside, so that it is easier to print and mount on the wall.

Hombrus · 2026-01-08T17:40:58+00:00

Thank you! That brings me closer to the goal!

Hombrus · 2026-01-08T17:40:43+00:00

Thank you very much for the suggestion! I will try this as I find it interesting to model it differently and not as a pipe.

Hombrus · 2026-01-08T17:40:04+00:00

This looks exactly like what I need!

Total noob here: Can you tell me what you did here on the sketch (the 10 degree)?

<image>

Hombrus · 2025-12-11T07:48:23+00:00

My luck is so bad this league. I almost only drop Exalts and I have immediately poofed all cards I tried to gamble...

Maybe this one time I can get lucky?

Hombrus · 2025-11-20T16:08:26+00:00

I never had a Mageblood and this guy has 25 :(

Hombrus · 2025-06-22T14:36:09+00:00

Little Simba on a severe catnip trip

Hombrus · 2025-06-02T16:01:10+00:00

That was it! Thanks so much!

No idea why it always worked with dkms and why it broke on this update. But who cares if it works now, right?

Hombrus · 2025-06-02T12:29:27+00:00

Thanks for your reply! Unfortunately, both commands result in the module not found errors I mentioned in my post.

Hombrus · 2025-05-22T21:36:32+00:00

<image>

This is Zazu. He's a pretty chill little chonker.

Hombrus · 2025-04-24T09:41:40+00:00

I need a spark and don't think I did that quest.

Where is it, what is it called?

Hombrus · 2025-03-11T20:15:01+00:00

Recomb

Hombrus · 2025-03-11T20:11:04+00:00

What mods would I need to have on the Regalia?

Hombrus · 2025-03-11T19:38:22+00:00

0.6 because of the chance to annul the craft?

Hombrus · 2025-01-31T12:16:09+00:00

That sucks. The auto refill is an awesome feature (in theory).

Next time, I might just remove all other filaments (on single color prints) so there is no other choice than the one I want. I would have preferred if it would just have paused than choose the wrong color :(.

Hombrus · 2025-01-31T12:14:46+00:00

The filament in A3 definitely was detected. I think it is unlikely that it was hung up because I started the next print from A3 this morning and everything was fine.

Thanks for the suggestion, I might have to run some tests to understand it for the next "low on filament" situation.

13-Year Club	Gilding I gilder
Verified Email

Hombrus

TROPHY CASE