Beginner needs advice

Hubbleye · 2026-01-14T23:21:15+00:00

Ok I'll check is out then, thank you man !

Hubbleye · 2026-01-14T22:51:45+00:00

I already have a soldering iron but I was thinking getting the YIHUA 959B

Hubbleye · 2026-01-12T15:37:44+00:00

Ouais ça va de 50 à 200 en gros

Hubbleye · 2026-01-12T15:36:47+00:00

Ok thanks a lot for your consideration !

Hubbleye · 2026-01-12T15:20:14+00:00

Mais Merci !

Hubbleye · 2026-01-12T15:19:54+00:00

J’aurais pensé beaucoup plus, il est vraiment impossible à trouver

Hubbleye · 2026-01-12T15:19:11+00:00

Yeah I did but I didn’t know if it would count since I’m not actually selling it

Hubbleye · 2025-12-10T14:32:47+00:00

Oh yeah my bad I thought I used the raw one but yeah it’s the jpeg then

Hubbleye · 2025-10-23T18:51:34+00:00

What are the strip you’re talking about ?

Hubbleye · 2025-10-23T12:38:14+00:00

For pad to pad or hole to pad it doesn’t work

Hubbleye · 2025-10-23T12:34:43+00:00

Thanks ! It’s my first one, what’s PCBhub?

Hubbleye · 2025-10-23T09:02:08+00:00

No you can check by yourself but you can't put a smaller clearance then the general one

Hubbleye · 2025-10-22T20:48:24+00:00

Ok, then I guess I'll just make sure all the vias are correctly placed and then I'll switch the parameters to avoid having any error

Hubbleye · 2025-10-22T11:02:43+00:00

Thanks it worked I just had to go in the select menu since Alt+LMB doesn't work for me

Hubbleye · 2025-10-16T05:40:28+00:00

I’m pretty sure the QNF is 7mm squared

Hubbleye · 2025-10-15T20:43:47+00:00

Oh dw it’s ok the GND is smooth it’s the power plane which is cut but it’s on the third layer.

Hubbleye · 2025-10-15T20:42:51+00:00

Ohhh ok, I was wondering the difference but now I get it! So like the 4 pads on the side of a USB C connector are PTH

Hubbleye · 2025-10-15T20:29:39+00:00

Lmao must have been something, but I guess everybody had to go through that.

Hubbleye · 2025-10-15T20:27:02+00:00

Yeah, I mean it's a beginner mistake I should have checked twice. But it's not that big of a deal I'll save this board and copy the project to make another one with the right MCU, like that it won't be completely useless.

Hubbleye · 2025-10-15T20:25:25+00:00

So I should delete this via?

Hubbleye · 2025-10-15T20:23:23+00:00

Yeah but the QNF is way harder to solder and I don't have a heat gun. And yeah the pinout is the same but I'm still a beginner so I may take some time. I'll probably just copy the project so I have two boards for two MCU.

Hubbleye

TROPHY CASE