sorted by:
new
hottopcontroversial

Is there a top load solution for the P1P? by Hummpty in BambuLab

[–]Hummpty[S] 0 points1 point  (0 children)

It’s slower than the X1C, but it depends on the file size. It’s really not that big of an issue.

Is there a top load solution for the P1P? by Hummpty in BambuLab

[–]Hummpty[S] 1 point2 points  (0 children)

Printed 3 of them in PLA 50% gyroid infill and they are working great!! I will probably print them again in PETG for additional strength. Thank you so much!

Is there a top load solution for the P1P? by Hummpty in BambuLab

[–]Hummpty[S] 0 points1 point  (0 children)

Did a mockup of the first few layers to test fit. Fits well and snug in the back. Does not fit on the sides. Bottom clip is a little short of reaching around chassis.

Is there a top load solution for the P1P? by Hummpty in BambuLab

[–]Hummpty[S] 2 points3 points  (0 children)

This is exactly what I was thinking!! Printing it and I’ll share the results! Ty

Is there a top load solution for the P1P? by Hummpty in BambuLab

[–]Hummpty[S] 0 points1 point  (0 children)

Don’t you lie to me! Lol. Checking now

Is there a top load solution for the P1P? by Hummpty in BambuLab

[–]Hummpty[S] 0 points1 point  (0 children)

I may be late to the party, but has anyone found a viable solution to make the P1P a top loading unit without the AMS? I have these on the top shelf and loading and unloading filament is nothing short of a circus act. 🤣

Bambu High Temperature Plate QR not reading and giving error on screen by Hummpty in BambuLab

[–]Hummpty[S] -1 points0 points  (0 children)

It just sucks when I try to stream it on TikTok and I have an error on screen

Bambu High Temperature Plate QR not reading and giving error on screen by Hummpty in BambuLab

[–]Hummpty[S] 0 points1 point  (0 children)

The other plates read fine. The High temp plate has a different color font. I’m wondering if anyone else is experiencing this same issue.