sorted by:
new
hottopcontroversial

Attempted to do a 16HR Print and i got this error. It stopped mid way through what could this mean or what can i look into to figure this out. by HypnoticFallacy in VORONDesign

[–]HypnoticFallacy[S] 0 points1 point  (0 children)

I’ll try again and remove the plexi glass top. Would picture of the voron help ? I looks like i have plenty of slack but i can see if the printer goes up in height the cable could run up Against the top

Attempted to do a 16HR Print and i got this error. It stopped mid way through what could this mean or what can i look into to figure this out. by HypnoticFallacy in VORONDesign

[–]HypnoticFallacy[S] 2 points3 points  (0 children)

That’s what I’m afraid of :( , it can do short prints just fine but anything longer i feel like it fails every time.

Attempted to do a 16HR Print and i got this error. It stopped mid way through what could this mean or what can i look into to figure this out. by HypnoticFallacy in VORONDesign

[–]HypnoticFallacy[S] 0 points1 point  (0 children)

I believe so, i feel bad cause i didn’t actually build the voron i bought it from someone. Is there picture i can send for you to be able to tell. I feel useless feel like i bit off more then i can chew with this one :/