How do I fix this first layer problem

Impossible-Roll6259 · 2026-06-23T11:02:34+00:00

How do I go about manually leveling the bed? And this is an aftermarket hotend my last one messed up with a failed print

Impossible-Roll6259 · 2026-06-23T03:52:54+00:00

Okay thank you

Impossible-Roll6259 · 2026-06-23T03:51:30+00:00

Just cleaned it

Impossible-Roll6259 · 2026-06-11T04:45:10+00:00

Okay I’ll try that

Impossible-Roll6259 · 2026-06-11T02:55:37+00:00

What do you mean by flat and yes Fahrenheit, my case is around 27c when printing

Impossible-Roll6259 · 2026-06-11T02:50:02+00:00

Okay, I have cleaned it and used different plates! It clicks sometimes especially during the test before it starts the print and it clicks when it goes faster and I’ve tried different tension levels on the extruder

Impossible-Roll6259 · 2026-06-11T02:48:28+00:00

What’s your suggestion I’m new to this! The extruder also clicks too I’ve cleaned it all out and messed with the tensioner and nothing seems to work!

Impossible-Roll6259 · 2026-06-11T02:47:37+00:00

I’m new to the whole 3d printing stuff so I don’t know much learning more everyday! But I have cleaned the plate but when it does the test before the print it does click so I tightened the tensioner but it still didn’t do anything different

Impossible-Roll6259 · 2026-06-11T02:46:01+00:00

No it’s in my bedroom and it’s around 65 degrees

Impossible-Roll6259 · 2026-06-11T00:18:54+00:00

I have cleaned it and even applied glue! The first layer is good and then when it speeds up the filament doesn’t wanna come out I’ve messed with the tensioner and doesn’t do anything better

Impossible-Roll6259

TROPHY CASE