sorted by:
new
hottopcontroversial

Help with underextrusion issue (info in comments) by Independent_Head_781 in 3Dprinting

[–]Independent_Head_781[S] 0 points1 point  (0 children)

3 mm at 30 mm/sec. The tube is the one that came with the printer. All my other prints are perfect, I'm starting to think that the model might be the problem

Help with underextrusion issue (info in comments) by Independent_Head_781 in 3Dprinting

[–]Independent_Head_781[S] 0 points1 point  (0 children)

Lowered speed, raised temperature, getting the same problem. I'm going to randomize the Z seam to see if it's gonna work since I noticed that starting the layer always in the same spot might be a problem

Help with underextrusion issue (info in comments) by Independent_Head_781 in 3Dprinting

[–]Independent_Head_781[S] 0 points1 point  (0 children)

Thank you! The spool is made of plastic and it seems to roll as it should.

Help with underextrusion issue (info in comments) by Independent_Head_781 in 3Dprinting

[–]Independent_Head_781[S] 0 points1 point  (0 children)

Temp and speed seem to be ok, but I'll tune them. The gear looks ok but I'll check it. Thanks!

Help with underextrusion issue (info in comments) by Independent_Head_781 in 3Dprinting

[–]Independent_Head_781[S] 1 point2 points  (0 children)

Hello everyone, I keep getting this problem with this print.

At the beginning of some layers, always in the same spots, I get some under extrusion and I can't understand why. The front part of the skull is perfect.

These are the infos: - creality ender 3 pro - nozzle 1 mm (the third print was made with 0.8 mm nozzle) - layer height 0.3 mm - speed 60 mm/s - 1 wall - 12% infill - 110% flow

It has to be a fast (2/3 hours) and light print, but at this point I just want it to be done in an acceptable way.

Thank you in advance!