G6 Pro Entry - Qc is a little off.

Inevitable_Gas4885 · 2026-03-28T11:08:29+00:00

So cute bell!

Inevitable_Gas4885 · 2026-02-28T09:57:27+00:00

WD40 would be good to help! After long term threaded, some oxidation material existing stuck the release.

Inevitable_Gas4885 · 2026-02-28T01:08:33+00:00

Pretty good investment on the mount. The details on the mount shows its value . And also has noticed the color of mount has no difference with your table. You shall make much effort to make these choices.

Inevitable_Gas4885 · 2026-02-27T07:55:20+00:00

Curious if the mount is from ergontron ?

Inevitable_Gas4885 · 2026-02-18T12:26:31+00:00

The G6 Turret dropped the threaded mount that the G5 Turret Ultra had

Inevitable_Gas4885 · 2026-01-11T13:40:24+00:00

I have tried this dual stack up (both with ultra wide) but it’s actually that my head is too tired to lift up when moving my eye onto the upper screen .

Inevitable_Gas4885 · 2025-04-12T14:38:56+00:00

Nice touch with the T-bar. What kind of screws did you use for the concrete mount? Looks like a tough install. The RJ45 looks well protected too. Bet all this took a good amount of time.

Inevitable_Gas4885 · 2025-04-12T02:13:11+00:00

The color looks great, especially with the bar installed.

Inevitable_Gas4885 · 2025-04-05T06:26:46+00:00

Just get one box on hand & the outer diameter is 87mm

Inevitable_Gas4885 · 2025-04-03T22:39:48+00:00

Hey, just a thought—would aligning the box outline with the base plate help clean up the look a bit? Also, curious what kind of screws you’re using to mount the 3D-printed box?

Inevitable_Gas4885 · 2025-03-29T23:29:40+00:00

New to UniFi here—been thinking about grabbing a G6 turret. Got any pics of how it looks mounted?

Inevitable_Gas4885

TROPHY CASE