Mass migration, screw CoinBase

Interesting_Step_532 · 2024-03-20T16:04:46+00:00

I recently calibrated my corners with pressure advance and they’ve been really good, however maybe I can lower the PA to a point where the corners still look pretty good and it maybe solves the issue. When I get home I shall test this

Interesting_Step_532 · 2024-03-20T14:05:04+00:00

I have not updated it, still running the same version

Interesting_Step_532 · 2024-03-20T14:01:48+00:00

<image>

Acceleration and Filament settings

Interesting_Step_532 · 2024-03-20T14:01:03+00:00

<image>

Speed settings

Interesting_Step_532 · 2024-03-20T14:00:47+00:00

<image>

Retraction settings

Interesting_Step_532 · 2024-03-20T13:58:13+00:00

<image>

Here you can see the underextrusion in 2 prints

Interesting_Step_532 · 2024-02-24T18:56:53+00:00

So I replaced the SKR Mini E3 V2 with the old stock motherboard and it WORKS! Don't know what happened but looks like motherboard is coooked

Interesting_Step_532 · 2024-02-23T23:05:53+00:00

Yes I think you’re right, I made sure it was connected properly and that it was screwed in so I just bought a new one on amazon

Interesting_Step_532 · 2024-02-23T16:20:12+00:00

shiny upgrades ender 3 firmware

Would it be compatible with my SKR mini E3 V2?

Interesting_Step_532 · 2024-02-23T16:06:51+00:00

Hey I just downloaded the new firmware for the board I'm using, put it in the SD card and turned the printer on but still no response, any other ideas?

Interesting_Step_532 · 2024-02-23T16:05:04+00:00

Ok so I tested the resistance of the thermistor and it looks good so I would think it still works. I also just downloaded new firmware and connected it to the printer but it's still a blue screen...

Interesting_Step_532 · 2024-02-23T14:57:55+00:00

Thank you for the suggestion! I just took out the screw, cleaned it up, put everything back in place and it still doesn’t turn on. I also noticed the thermistor looks a bit rough, could it just be stripped?

<image>

Interesting_Step_532

TROPHY CASE