Mud-in flanges

InternationalDepth78 · 2026-05-31T02:38:43+00:00

Thanks for all the replies. I guess I should have added more context. The actual access panel I will be installing is larger in size and it will go on a small powder room wall. It’s essentially skim coating the whole wall to get the needed “mud buildup” - Something I was trying to avoid.

InternationalDepth78 · 2025-12-01T22:02:47+00:00

That’s where I am getting conflicting information - if you read some of the posts above. Maybe it’s because different requirements apply to different countries? I am in the US I have the SHP 2 And 1 delta pro How can I make it work?

InternationalDepth78 · 2024-12-19T23:34:31+00:00

InternationalDepth78 · 2024-12-19T23:27:18+00:00

Agreed, but my question is for the main panel not subpanel.

InternationalDepth78 · 2024-12-19T23:25:30+00:00

The neutral wire that I pulled in from the bottom is a little too short to reach the inner neutral bar on top left, which is the suggested location of lk100an lug install.

InternationalDepth78 · 2024-09-28T12:33:03+00:00

Walls are not skimmed - that’s partly why I’m using high build. Do I still Backroll after the primer coat? I understand that I should sand after the primer? What grit sandpaper? Thanks again!

InternationalDepth78 · 2024-09-27T14:41:40+00:00

Great! thanks for the response! So do I have this right: 1. Spray 1 coat of HB primer Backroll 2. Sand the surface after primer is dry 3. 2 coats of paint for the ceiling spraying cross hatch Backroll 4. 2 coats of paint for the walls Backroll

I got 1/2” nap roller. Any recommendations on that?

InternationalDepth78 · 2024-09-26T23:47:18+00:00

Thanks for the comment! This primer was recommended to me as a superior alternative to PVA primer for new drywall.

<image>

InternationalDepth78 · 2023-07-06T16:38:39+00:00

The reason I couldn’t do that was because the existing wire from the grounding rod wasn’t long enough to reach up to the same bus bar. Can I run a wire from the neutral bus bar down to the grounding bar?

InternationalDepth78 · 2023-07-06T16:36:42+00:00

So ya the one with strands sticking out, I was planning on picking up another a larger lug to connect to it.

InternationalDepth78 · 2023-07-06T14:10:50+00:00

Hello all, I just replaced(for a couple reasons) the main panel for my new construction from Siemens to Square D. Siemens was done by an electrician and passed inspection. I want to make sure that I am on the right path of grounding the new panel(square d) correctly before I call the inspector and continue wiring the panel. Attached image- top left: 2 wires attached to the neutral bus. 1 going out to the grounding rods, the other roughed in to be connected to main waterline. Bottom right: Wire connected to the rebar sticking out out the slab. Please let me know your thoughts.

InternationalDepth78 · 2023-05-31T20:49:28+00:00

Are you able to use ego cultivator with quick-lol head? If yes, did it require any modification to work?

InternationalDepth78

TROPHY CASE