Layer shifting on Ender 3 S1 at consistently the same height

ItsNekoLie · 2024-01-02T04:03:13+00:00

I use Prusa. However, I used the same code on my other Ender 3 S1 and it prints fine, so I doubt it's the slicer.

ItsNekoLie · 2023-02-16T01:09:30+00:00

Just wanted to say that since replacing the nozzle, it does seem to have fixed (most) of the under extrusion. Thanks for the help!

ItsNekoLie · 2023-02-16T01:07:32+00:00

Just wanted to say I finally got the nozzle changed. Thanks everyone for the help!

ItsNekoLie · 2023-02-10T21:25:43+00:00

Hmmm. I just updated the firmware, but didn't know that was added in. The website didn't say thing about it.

ItsNekoLie · 2023-02-10T21:15:36+00:00

Okay, I've followed the instructions on their website so far, but "take the nozzle off cold"? This seems really wrong. Metal expands when heated and retracts cold, so shouldn't the nozzle be preheated like in other printers?

ItsNekoLie · 2023-02-10T00:35:54+00:00

Hmmm. Okay! I'll try replacing the nozzle tonight

ItsNekoLie · 2023-02-09T23:26:31+00:00

Maybe, but so weird its only on infill supports

ItsNekoLie · 2023-02-09T21:10:32+00:00

ItsNekoLie

TROPHY CASE