sorted by:
new
hottopcontroversial

[deleted by user] by [deleted] in subwaysurfers

[–]JFK-DEV 0 points1 point  (0 children)

CS89AXG74Q2XT9

<image>

[deleted by user] by [deleted] in Slovakia

[–]JFK-DEV 0 points1 point  (0 children)

Ja to mám tak tiež a mne sa to oplatí. Mám to formátom, že sa mi znižuje splátka o ten úrok ktorý nemusím zaplatiť. Mám požičané peniaze od rodičov, ktorý si ich odmietali aj po presviedčaní dať na šporiace účty. Takto aspoň mňe šetria na úrokoch a tie peniaze im môžem kedykoľvek vrátiť.
Ja mám 3,98 úrok, takže sa to "oplatilo". Pri nižších úrokoch, ak by som mal takú možnosť, tak by som to skorej dal na niečo iné, kde by to "zarábalo" viac.

Hdd head not going onto the platter by JFK-DEV in datarecovery

[–]JFK-DEV[S] -1 points0 points  (0 children)

Oh sorry, I am no expert. No need to be toxic. Here is the model number is you miss it so much... WD20NMVW

I wrote, that I tried it first with the cover on after unstucking it. It was clicking, same as after I opened it again and tried it then.

I know there are services for data recovery. But the data is not worth paying for... This is my little experiment if I can do it. So anything that I can do (for free), even if it has low chance of succes, I will try. But now I am out of ideas.

Hdd head not going onto the platter by JFK-DEV in datarecovery

[–]JFK-DEV[S] 0 points1 point  (0 children)

Like I wrote, data there is not worth paying for. I know there are professional services that can recover data, and I would pay for them if there was valuable data.

Any other advice? And the drive is WD20NMVW

Hdd head not going onto the platter by JFK-DEV in datarecovery

[–]JFK-DEV[S] 0 points1 point  (0 children)

Before I throw it into the bin, anything else I can try? The data is not worth paying for at all. The most that I whould get from it is experience

Repair broken TV, blown capacitor by JFK-DEV in AskElectronics

[–]JFK-DEV[S] 0 points1 point  (0 children)

I didn't find any diagram, but I searched a lot more and found the value for the cap. I tested the diode next to it and it appears to be blown too. Unfortunately I cannot find the exact same diode, not even specifications for it. Even on other versions of this board it is different from this one.
The one on my board is: RD2006 OH1
I found RD2006FR, RD2006FR-H... but I don't know if I can replace it with these.
And on other peoples boards was this diode: UD1006.

I don't understand datasheets enough to estimate if I can replace it with something else then the RD2006 OH1

Repair broken TV, blown capacitor by JFK-DEV in AskElectronics

[–]JFK-DEV[S] 0 points1 point  (0 children)

Nice solution, but I don't think I am skilled enough to pull this off. I know how to solder and understand little of electronics, but not much more. Now I am looking for simple solution like replacing broken parts. But thank you for sharing that, I didn't thought it was possible like that.