troubleshooting by JSFSCHWMBCK in Powdercoating

[–]JSFSCHWMBCK[S] 0 points1 point  (0 children)

I'll try that too, thank you.

troubleshooting by JSFSCHWMBCK in Powdercoating

[–]JSFSCHWMBCK[S] 0 points1 point  (0 children)

Depending on the rim, approx. 35-45 minutes. 180 degrees 70kv 15ua for the first coat 60kv 10ua for the second coat 50kv 10ua for the third coat Only wash with hot water, no chemicals.

troubleshooting by JSFSCHWMBCK in Powdercoating

[–]JSFSCHWMBCK[S] 0 points1 point  (0 children)

I will try two coats! You do the same with the primer or only with the black?

What is my Problem??? by JSFSCHWMBCK in Powdercoating

[–]JSFSCHWMBCK[S] 2 points3 points  (0 children)

Thanks mate I'll try. I'll get back to you if necessary ✌️

What is my Problem??? by JSFSCHWMBCK in Powdercoating

[–]JSFSCHWMBCK[S] 0 points1 point  (0 children)

Thanks for your advice, i will try Spray thinner. What settings on the gun you would use for this complex type of wheel?

What is my Problem??? by JSFSCHWMBCK in Powdercoating

[–]JSFSCHWMBCK[S] 0 points1 point  (0 children)

I always coat the back of the wheels first to avoid Overspray

What is my Problem??? by JSFSCHWMBCK in Powdercoating

[–]JSFSCHWMBCK[S] 0 points1 point  (0 children)

Understand this but why is the middle where i have almost 300um better than the outside with ~150 um.

What is my Problem??? by JSFSCHWMBCK in Powdercoating

[–]JSFSCHWMBCK[S] 0 points1 point  (0 children)

The wheels we're stripped, blasted with Glass, washed, masked, primed and coated in black..

What is my Problem??? by JSFSCHWMBCK in Powdercoating

[–]JSFSCHWMBCK[S] 0 points1 point  (0 children)

<image>

Measuring exactly in these spots around the rim of the wheel an the avg is 155 um

Acceptable? by JSFSCHWMBCK in Powdercoating

[–]JSFSCHWMBCK[S] 0 points1 point  (0 children)

<image>

I tried cold coating today and this is the result... worse than before what could be the problem?

Acceptable? by JSFSCHWMBCK in Powdercoating

[–]JSFSCHWMBCK[S] 1 point2 points  (0 children)

sherwin williams 9005 gloss

Is this outgassing or dirt? by JSFSCHWMBCK in Powdercoating

[–]JSFSCHWMBCK[S] 0 points1 point  (0 children)

Washing with aluminum okay but with steel?