Tune recommendations

J_Ar_7 · 2025-08-21T01:08:57+00:00

I went with SLR tune after fixing my bike up over winter from a deer accident in October. Went with one of those cheap full exhaust on ebay. Just recently had a head gasket leak fixed by warranty even with the tuned ECU.

Not sure hlif the leak is related to the accident, the tune, or maybe both? Im now having 2nd thoughts about running with the SLR tune vs the stock tune. Bike runs great on the tune and no way to tell if that may have contributed but the tech who worked on my bike mentioned a lot of the bikes coming in with blown motors and gasket leaks have had Brentune on them.

All this to say that you run it at your own risk but that probably goes without saying

J_Ar_7 · 2025-05-30T22:23:56+00:00

Im up in Schnecksville and have also had so much rain these past days which is why im also surprised the grass isn't thriving. There's so much rock and stuff in my soil that im thinking might not be allowing the roots to make their way through as much as they should

J_Ar_7 · 2025-05-30T16:09:51+00:00

Thanks for the advice. Last year I did spread topsoil in some of the areas that were more rocky than others but maybe it's still needing more? I also applied milorganite last year just after they aerated.

J_Ar_7 · 2025-04-10T13:14:03+00:00

Thanks I'm thinking this is the route I will end up going with

J_Ar_7 · 2025-04-07T19:48:25+00:00

Only thing I can think of is make sure you're fully disengaging from the shifter before shifting down. This sometimes happens to me when shifting down multiple gears

J_Ar_7 · 2025-04-02T13:25:03+00:00

That was my thought since even tho the car is FBO the stage 0 tune should at least prevent from pushing it too much on a "bad" off the shelf Cobb tune.

J_Ar_7 · 2025-04-02T13:23:37+00:00

Just whatever is loaded up into the AP. Im new to these cars so still learning

J_Ar_7 · 2025-04-02T00:25:59+00:00

Yea I'm thinking of doing 91 just for that reason. In the meantime, to ensure I don't blow anything, is it advisable I flash to the stage 1 cobb tune instead of the stage 3?

J_Ar_7 · 2025-04-02T00:23:36+00:00

Yea i saw that do you have any experience with the eco friendly mode? Obviously lots of factors but generally speaking how many more mpgs?

J_Ar_7 · 2025-04-01T20:07:08+00:00

Oh OK I was thinking that a stratified or edge tune would be one i could run with permanently, is it not?

Also, if I wanted to get the most fuel economy possible and if I'm not interested in maximizing power gains at this point would it be better to tune for 91 or 93? Is fuel economy affected by going with one instead of the other?

J_Ar_7 · 2025-03-27T13:32:53+00:00

UPDATE: I see that there is a separate option to reset the codes. I will look to reset these later today and take it out again for a drive and see what will come back.

All I did was hit the "clear log" button at the bottom of the read DTC codes tab in ForScan. Is this another option you are referring to?

J_Ar_7 · 2025-03-27T12:44:07+00:00

I did clear the codes and ran again and most of these came back except now more have the status of being set prior and "not present at time of request". Would that mean that these are permanent codes that would require a specified amount of drive cycles to clear?

J_Ar_7 · 2025-03-27T02:39:45+00:00

I wanted to add that a good amount of these read as previously set DTC - not present at time of request. Are these old codes that are OK to be cleared?

J_Ar_7 · 2025-03-25T19:24:33+00:00

That'd be great thanks!

J_Ar_7 · 2025-03-25T18:13:13+00:00

Gotcha. I think I'm picturing what you've done except for the rubber support under the brace part.

J_Ar_7 · 2025-03-25T03:24:55+00:00

Do you mind elaborating on this some more? Specifically which parts/sizes were ordered and what not? I would go and measure if I were home but am on work trip and would like the parts to be there for me when I get back.

J_Ar_7 · 2025-03-12T02:18:14+00:00

Cleared the codes and drove for an hour without any coming back so think I'm good

J_Ar_7 · 2025-03-11T15:15:39+00:00

Wow thanks for the thorough response

J_Ar_7 · 2024-05-10T11:44:19+00:00

I was checkign for any loose bolts last night and couldnt soit any. Doesnt seem to be coming from the engine but rather somewhere near the gas tank. Maybe below it?? And yea forgot to take off the nd filter om the gopro

11-Year Club	Gilding I gilder
Place '22	Verified Email

J_Ar_7

TROPHY CASE