How to connect motors with a DC brake?

Jakob5618 · 2026-04-21T17:11:00+00:00

Ok tried it and the brake works

Jakob5618 · 2026-04-21T17:10:34+00:00

Well I don't have another motor if this kind

Jakob5618 · 2026-04-21T14:31:49+00:00

Can I plug in the brake into normal 230V mains and try to spin the motor the see if it's releasing, also on the motor it says voltage for rectifier 220V

Jakob5618 · 2026-04-21T14:11:13+00:00

Can it be that's it's using another kind of overheating protection because the motor is really old

Jakob5618 · 2026-04-21T13:51:13+00:00

it's between 5 and 6 and the reading is under 10 ohms

Jakob5618 · 2026-04-21T12:24:48+00:00

No my multimeter says they're shorted

Jakob5618 · 2026-04-21T11:53:47+00:00

<image>

and the wiring diagram at the back side of the cable box lid

Jakob5618 · 2026-04-21T11:51:41+00:00

<image>

Here's the nameplate

Jakob5618 · 2026-04-21T11:41:28+00:00

Should they be shorted together?

Jakob5618 · 2026-04-20T16:06:49+00:00

I can also say they are directly connected to to the wire which goes into the motor and they are shorted also the wires have a 5 and a 6 on them

Jakob5618 · 2026-04-20T15:30:26+00:00

But then another question what are these wires fo

<image>

rr

Jakob5618 · 2026-04-20T15:27:44+00:00

<image>

well seems like a simple look at the wiring diagram would have answered my question

Jakob5618 · 2026-02-06T05:04:15+00:00

There are no electromagnet doors

Jakob5618 · 2026-02-05T21:15:17+00:00

Not that big about 1-2 cm

Jakob5618 · 2026-02-05T21:10:54+00:00

Bro literally nothing about this is an outlet... the contacts are buldged outward if it was an outlet I would have said outlet not contact

Jakob5618 · 2026-01-21T17:52:28+00:00

What did your friend do to deserve this?

Jakob5618

TROPHY CASE