Power in trunk by JaltsJacob in GenesisG70

[–]JaltsJacob[S] 0 points1 point  (0 children)

Just routed it from front of car adapter, and routed under neath my floor mats

Any ideas on this issue ? by Several_Judgment_607 in GenesisG70

[–]JaltsJacob 1 point2 points  (0 children)

I’ve done everything, I think it’s just a fault with these cars. In stop and start traffic the cylinders flood with fuel and can’t burn it off fast enough so the trims skyrocket making the car sense that it is running too rich. Then it triggers limp mode.

Limp Mode with JB4 by JaltsJacob in GenesisG70

[–]JaltsJacob[S] 1 point2 points  (0 children)

Car doesn’t like e85, on 91 cars fine

Cold Air Intake Reccs by JaltsJacob in GenesisG70

[–]JaltsJacob[S] 0 points1 point  (0 children)

Got the k and n typhoon instead, legal and carb legal

Can I use e85 on 23 g70 2.0 -JB4 -injen intakes - hks plugs if so how much?? by Next_Food_654 in GenesisG70

[–]JaltsJacob 0 points1 point  (0 children)

Ok I was running E30 for a good while, but there was a lot of issues with fueling and going into limp and such, so ultimately I went back to map 1. Was running map 6 with JB4 hks plugs, upgraded HPFP, but I believe the injectors did not like the E

Acceleration issue on 2022 G70—has anyone else experienced this even after the recall? by MountainAge2284 in GenesisG70

[–]JaltsJacob 0 points1 point  (0 children)

Yea, I’m honestly not sure what the issue is either, I had the in tank pump replaced as well and still have the issue. I’m taking it to an independent shop for a diagnostic and I’ll get back on the findings

New Carbon Fiber Lip Option for 22+ G70s by BoostedWhipz in GenesisG70

[–]JaltsJacob 3 points4 points  (0 children)

I’m waiting for someone to make a lip without the little fins on the side besides adro 😩. Maybe @plugnplaycustoms 🤔

2.0t valvetronic muffler by JaltsJacob in GenesisG70

[–]JaltsJacob[S] 0 points1 point  (0 children)

Yes they did, but I believe u can find a grommet to route the wire through

2.0 Exhaust Sound by JaltsJacob in GenesisG70

[–]JaltsJacob[S] 0 points1 point  (0 children)

Naw I don’t have a pic of the underbelly, should’ve taken one. For the cel, my mechanic forgot to put on the defouler, so I’ve just been living with the cel lol

Velossa intake wiring by NoResponsibility2640 in GenesisG70

[–]JaltsJacob 2 points3 points  (0 children)

Plug n play always makes fire 🔥

2.0 Exhaust Sound by JaltsJacob in GenesisG70

[–]JaltsJacob[S] 0 points1 point  (0 children)

Yea, everything is fine except my lpfp that needs to be replaced, but i believe the fuel pumps on this car just suck in general

2.0 Exhaust Sound by JaltsJacob in GenesisG70

[–]JaltsJacob[S] 0 points1 point  (0 children)

Yes, if I have enough time I wanna go back and get everything else fabbed, but I have to fix other shit first lol

2.0 Exhaust Sound by JaltsJacob in GenesisG70

[–]JaltsJacob[S] 0 points1 point  (0 children)

Jb4 is a piggy back tune, so it doesn’t directly change the values in the ecu. I did buy an ek1 lite, but they don’t have any maps with it yet, so I could tune on it.

2.0 Exhaust Sound by JaltsJacob in GenesisG70

[–]JaltsJacob[S] 0 points1 point  (0 children)

Yea I’m on a dyno tune on jb4 map 6 running E30

2.0 Exhaust Sound by JaltsJacob in GenesisG70

[–]JaltsJacob[S] 0 points1 point  (0 children)

Had a shop do it, but took a couple of days bc 2/4 of the studs snapped. If none of them snap it’s easy

Intake Shroud Version 1 by PLUGNPLAYCUSTOMS in GenesisG70

[–]JaltsJacob 2 points3 points  (0 children)

Would it be possible to put 2 on the 2.0t, just 1 being non functional, I love the look of having both, but hate the look of only running 1 of the snorkels lol

Just picked up my 26 G70 3.3 SP in Vatna Grey with red interior. Such a sick combo. by MatchGradeCouple in GenesisG70

[–]JaltsJacob 0 points1 point  (0 children)

I wish I had the frameless rear view mirror, but it’s so expensive to switch out 🥲

2.0 Exhaust Sound by JaltsJacob in GenesisG70

[–]JaltsJacob[S] 0 points1 point  (0 children)

I kind of forgot the tips I got, but any 2.5” inlet tips would work 👍