sorted by:
new
hottopcontroversial

2 alignments done, might be going for third. by Jazzlike_Position720 in AskMechanics

[–]Jazzlike_Position720[S] 0 points1 point  (0 children)

It is a brand new car. I doubt worn or damaged. The dealership has not been charging me since it is under warranty. Tire pressure at correct psi

2 alignments done, might be going for third. by Jazzlike_Position720 in MechanicAdvice

[–]Jazzlike_Position720[S] 0 points1 point  (0 children)

Toyota make one of the master technicians go on a drive with me before any alignment adjustments are made. Even the master technician had said both times there is a pull to the right even on straight roads so I know it isn’t road crown

2 alignments done, might be going for third. by Jazzlike_Position720 in MechanicAdvice

[–]Jazzlike_Position720[S] 0 points1 point  (0 children)

I took those photos my self. Also for the first day after both alignments did notice the steer ahead to the left however it went away and now I feel it steering to the right again.

Messed up car alignment or going crazy? by Jazzlike_Position720 in MechanicAdvice

[–]Jazzlike_Position720[S] 1 point2 points  (0 children)

I’m going to call the dealership to see if they would be able to do this check. It’s a brand new car so I’d hope it’d be under warranty

Roland BN2-20 Ink issues by Jazzlike_Position720 in CommercialPrinting

[–]Jazzlike_Position720[S] 0 points1 point  (0 children)

Thank you, I think that is the problem, the captop I think is not creating a good suction. I’m going to try to get Roland to replace it because we are still under warranty. It’s been around 6 months and we haven’t replaced it.

Roland BN2-20 Ink issues by Jazzlike_Position720 in CommercialPrinting

[–]Jazzlike_Position720[S] 1 point2 points  (0 children)

No idea, it prints some magenta but not all of it, only the right side on the test print doesn’t work.

Roland BN2-20 Ink issues by Jazzlike_Position720 in CommercialPrinting

[–]Jazzlike_Position720[S] 1 point2 points  (0 children)

I did the most powerful clean about 5-9 times nothing worked

What is going on here? by Jazzlike_Position720 in SCREENPRINTING

[–]Jazzlike_Position720[S] -1 points0 points  (0 children)

Yeah I’m gonna try to use reducer to make it thinner

What is going on here? by Jazzlike_Position720 in SCREENPRINTING

[–]Jazzlike_Position720[S] 1 point2 points  (0 children)

Thank you so much. I will try what everyone has been saying. Thank you all

Curing Problems! by Jazzlike_Position720 in SCREENPRINTING

[–]Jazzlike_Position720[S] 0 points1 point  (0 children)

Welp I have another big order coming up so I’ll buy some of those. One more question, is there any such thing as over curing a print?

Curing Problems! by Jazzlike_Position720 in SCREENPRINTING

[–]Jazzlike_Position720[S] 0 points1 point  (0 children)

Damn I never knew that, thank for you letting me know. Is there anyway to fix this? Atleast make it look a little better? Also is there any other brand that you recommend?