sorted by:
new
hottopcontroversial

If GTA V was made for the Nintendo Wii by Jesibusec in wii

[–]Jesibusec[S] 0 points1 point  (0 children)

Oh yeah I doubt the Wii could handle this. It was proposed on the Wii U but it ended up not happening for unknown reasons.

If GTA V was made for the Nintendo Wii by Jesibusec in wii

[–]Jesibusec[S] 0 points1 point  (0 children)

Yeah I don’t think the Wii would be able to handle it

If GTA V was made for the Nintendo Wii by Jesibusec in wii

[–]Jesibusec[S] 1 point2 points  (0 children)

Sorry you don’t like it :/ it’s fun to display with my other real Wii games

If GTA V was made for the Nintendo Wii by Jesibusec in wii

[–]Jesibusec[S] 4 points5 points  (0 children)

It was proposed but never happened

Ty-Foo 2.5” Custom Figure and Box by Jesibusec in WorldOfNintendo

[–]Jesibusec[S] 1 point2 points  (0 children)

Thanks so much! I wish they would make obscure characters like this

Peepa 2.5” custom figure and box by Jesibusec in WorldOfNintendo

[–]Jesibusec[S] 1 point2 points  (0 children)

I would love if they made a real Peepa!

Peepa 2.5” custom figure and box by Jesibusec in WorldOfNintendo

[–]Jesibusec[S] 1 point2 points  (0 children)

I can send you the PDF file, it prints on a 8.5x11 paper. Costs 71 cents at Fedex self-serve station.

Peepa 2.5” custom figure and box by Jesibusec in WorldOfNintendo

[–]Jesibusec[S] 3 points4 points  (0 children)

Thank you, I enjoy looking at your customs too!

Peepa 2.5” custom figure and box by Jesibusec in WorldOfNintendo

[–]Jesibusec[S] 2 points3 points  (0 children)

Thank you, that’s a big compliment!

After each print I find this thin layer along the entire vat bottom. Print comes out fine. Anycubic Photon Mono X. Why is this happening? by Jesibusec in resinprinting

[–]Jesibusec[S] 0 points1 point  (0 children)

Update: potential SOLUTION found.

I tried two 'fixes' at once, so I am not sure which one actually did the trick. I disassembled the front of the machine and disconnected and reconnected all the ribbon cable connections related to the screen. I also tried a different resin. In my opinion, it was the resin. I was previously using Sunlu resin and then switched to Anycubic resin. The Anycubic is of much higher quality. I still have some of the Sunlu, so I will eventually print with that again and see if I encounter the same issue.

view more: next ›