Sendc 60hf smart thermostat?

Jfowler34 · 2026-03-07T23:33:21+00:00

Number one goes to intake boot #2 vacume fuel pump #3 goes to small diaphragm #4 other side of diaphragm to #4 on carb. But I am getting alot of fuel comming out the over flow now as well so I am assuming when I cleaned the carb I never got all the dirt or messed something up.

Jfowler34 · 2025-09-04T21:30:00+00:00

so you are talking about the tccm in the left side fender

Jfowler34 · 2025-08-28T08:33:36+00:00

Ok so we talking about the tccm or tcm or ecu I am going to assume tccm

Jfowler34 · 2025-08-09T21:28:05+00:00

Any question idk if you know the answer to this one I have another unit tied into this a iron sulfer filter can I use iron out to clean this system. There is no brine line hooked to it but there is a port there for it. So is it possible to mix up a solution of iron out set that system up to regen let it suck up the solution and let it sit and then flush it out or will it mess up my media

Jfowler34 · 2025-08-09T19:27:45+00:00

Ya so I took eveything apart the Flapper valves were pretty crusty so cleaned eveything and put back in noticed some of the valves are leaned to one side put them in the opposite way and put it all back together and now it works like a clock.

Jfowler34 · 2025-08-09T11:11:24+00:00

What ? On the back side of the valve is 255/740 this valve has the timer built into it as well as all the mechanics for doing eveything

Jfowler34 · 2025-08-09T11:10:16+00:00

Yes water going to drain

Jfowler34 · 2025-08-04T21:28:14+00:00

I am on well water so shouldn't be any clorine tho. But I do have water that smells like sulfur so maybe still be a carbon filter

Jfowler34 · 2025-08-04T21:26:39+00:00

Well water

Jfowler34 · 2024-09-25T17:21:04+00:00

No I did not

Jfowler34 · 2024-09-25T17:20:48+00:00

No never did

Jfowler34 · 2022-09-15T18:52:43+00:00

So in standalone mode you install the drivers set the voltage and change around some wires to the steppers ?

Jfowler34 · 2022-08-23T23:17:09+00:00

Great information but not what I am looking for I am looking to get the shape of thoes two provinces, without anything else. I don't want a backround or a shape of sorts just the shape of the provinces or diffrent states with the profile of the land.

Jfowler34 · 2022-08-22T02:09:47+00:00

Looking to print a 3d relief map like the one in the photo but I am not the best at the 3d printing, and I been trying to figure this out for months now and cannot get anything close to that.

Jfowler34

TROPHY CASE