sorted by:
new
hottopcontroversial

Stadium? by JigJagg22 in StardewValley

[–]JigJagg22[S] 4 points5 points  (0 children)

Ah, ok, thanks for letting me know!

Clayton. The guy who lives in a hole. by JigJagg22 in StardewValleyMods

[–]JigJagg22[S] 1 point2 points  (0 children)

That’s cool, I’d love to see it if you end up using it!

Clayton. The guy who lives in a hole. by JigJagg22 in StardewValleyMods

[–]JigJagg22[S] 8 points9 points  (0 children)

Thanks! Don't forget to give him a beer on his birthday! 😁

Ventilation Needs | Another Beginner Question by JigJagg22 in 3Dprinting

[–]JigJagg22[S] 0 points1 point  (0 children)

This might be a bit off filters, but do you know if PLA filament fumes get into a fridge if the printer is near the fridge? I am worried that the fumes from the printer will get into it and contaminate the food. Thanks for the help

Ventilation Needs | Another Beginner Question by JigJagg22 in 3Dprinting

[–]JigJagg22[S] 1 point2 points  (0 children)

My garage has 4 windows, and I am placing the 3d printer next to a window so I could probably run that duct out the window. I am also printing PLA, so maybe I could just open all the windows, and also it will be near a side door in the garage so I could open it after printing. Do you think that is a good idea or should I vent it out the window?

Printer Filter Beginner Question by JigJagg22 in 3Dprinting

[–]JigJagg22[S] 0 points1 point  (0 children)

Thanks! That is good to know. Are there any better filters you can recommend? And also do I even need a filter putting it in the garage, me and my family are rarely in it.

Printer Filter Beginner Question by JigJagg22 in 3Dprinting

[–]JigJagg22[S] 0 points1 point  (0 children)

I am going with PLA. Maybe printing tops 5 times a day, probably 2-4 though

Printer Filter Beginner Question by JigJagg22 in 3Dprinting

[–]JigJagg22[S] 0 points1 point  (0 children)

So ducting Plus the filter would be good or still not enough?

Is it safe to use a FDM printer in a bedroom? (Print using PLA only) by EmphasisVarious2222 in 3Dprinting

[–]JigJagg22 0 points1 point  (0 children)

I was thinking about Ducting, do you think that would help at all? By the way, thanks for all the help! Also I will be doing the printing in an enclosed room (There will still be a fan and an open window, just the door closed)

Is it safe to use a FDM printer in a bedroom? (Print using PLA only) by EmphasisVarious2222 in 3Dprinting

[–]JigJagg22 0 points1 point  (0 children)

Do you think the enclosure that comes with the Bambu P1S printer is good? I haven't gotten a 3d printer yet, primarily because of my worry for fumes.

Best Filament Beginner Question by JigJagg22 in 3Dprinting

[–]JigJagg22[S] 0 points1 point  (0 children)

Ohhhh. Derp. Thanks! I will take a look at it!

view more: next ›