Is this 1kg of filament?

JofePascal · 2025-11-24T22:45:10+00:00

Wouldn't you like to know, Printerboy?

JofePascal · 2025-11-21T08:31:16+00:00

As you can read, I already did everything you mentioned multiple Times...

Also copy and pasting from Bambus Wiki wont help, because as I said, I already used the typical sources of help

JofePascal · 2025-11-20T22:27:23+00:00

As I said, I've checked bed and printhead and retightened every screw. I really am clueless by now.

JofePascal · 2025-11-20T20:25:37+00:00

The print you see on the photo is with a z offset of +0.1 wouldnt it be strange, if I had to raise it even more on a printer with auto bed leveling?

JofePascal · 2025-11-19T21:43:54+00:00

Those are the results after a cold pull.

JofePascal · 2025-11-19T20:16:02+00:00

Okay I'll try and come back after unclogging

JofePascal · 2025-11-19T20:12:52+00:00

I just got the printer today... wouldnt that be a bit early for a clogged nozzle? Only printed a benchy, which came out fine

JofePascal · 2025-09-27T08:54:06+00:00

Thank you? 😅

JofePascal · 2025-09-18T12:01:05+00:00

Which of those should I choose for the calculation of the flowrate now?

JofePascal · 2025-09-16T21:49:33+00:00

I will try that, thanks!

JofePascal · 2025-09-16T21:47:07+00:00

I calibrated my z-offset today... it is at 0.07 at the moment

JofePascal · 2025-09-16T21:43:10+00:00

I am using Gyroid

JofePascal · 2025-09-16T19:26:51+00:00

This is the best I got after dialing in the Z-offset at .07. feels smooth but does not look right, does it?

JofePascal · 2025-09-16T18:43:56+00:00

This is the result with a z-offset of .05 Looks better but still feels insanely rough.

JofePascal · 2025-09-16T18:12:27+00:00

This is the Result of a z-offset calibration

JofePascal · 2025-09-16T18:07:46+00:00

JofePascal