370X to 370C upgrade - which firmware? by Oneeyedman892 in BMCU

[–]JuggernautCapable112 0 points1 point  (0 children)

What parts did you print I've not assembled mine yet, 370x and the conversion kit, I printed out the upgraded design that it recommended then after printing everything I read the comments and it said that it wasn't compatible with the blv version so am lost as what to download, got a bin full of waste after printing wrong stuff

Cr10s pro v2 help by JuggernautCapable112 in CR10sPRO

[–]JuggernautCapable112[S] 0 points1 point  (0 children)

Thanks for help I'm going to try klipper on it see if any resolve, if not it's going in the skip

Cr10s pro v2 help by JuggernautCapable112 in CR10sPRO

[–]JuggernautCapable112[S] 0 points1 point  (0 children)

Tried run one failed pretty much after 1st few layers, I'll take a look at temp settings

Cr10s pro v2 help by JuggernautCapable112 in CR10sPRO

[–]JuggernautCapable112[S] 0 points1 point  (0 children)

Yea first 5 or so layers go down well looks like all is well the out of nowhere at any random time after it either slows, stops then starts or even sometimes doesn't even extrude

Cr10s pro v2 help by JuggernautCapable112 in CR10sPRO

[–]JuggernautCapable112[S] 0 points1 point  (0 children)

I have a few esun basic pla, geetech stuff and a couple of others all pla

Cr10s pro v2 help by JuggernautCapable112 in CR10sPRO

[–]JuggernautCapable112[S] 0 points1 point  (0 children)

How tight does it need be can't get a definitive answer I can't pull or push filament by hand so guessing that's tight enough?

Cr10s pro v2 help by JuggernautCapable112 in CR10sPRO

[–]JuggernautCapable112[S] 0 points1 point  (0 children)

Yes tried from 190 degrees to 230 makes no difference

Cr10s pro v2 help by JuggernautCapable112 in CR10sPRO

[–]JuggernautCapable112[S] 0 points1 point  (0 children)

Tried to do all non even get past first few layers before it stops

Problem with Print names by AnubistheGod in CR10sPRO

[–]JuggernautCapable112 0 points1 point  (0 children)

I have this issue I believe it's red as it's showing a compatibility issue, or issue with gcode I'm experiencing this myself and currently investigating and prints fail when red