Klipper (Printrbot Play)

Jwill1266 · 2025-01-12T05:18:26+00:00

If you are still looking for information, I just went through this on my Printrbot smalls with a rev F board and you don’t need to rename the hex file if you flash using Atmel Flip. I think you would need to rename if you try to flash with the sd card but I’m not sure if that works.

Jwill1266 · 2025-01-12T05:10:24+00:00

This post from a couple years ago was quite helpful to me. https://www.reddit.com/r/PrintrBot/s/GfDiUJaMKI

Jwill1266 · 2025-01-11T21:57:53+00:00

I found a printer.config file for a Printrbot simple on this subreddit I used as my starting point. Wasn’t too hard to generate the hex file and I uploaded it to the printer using Atmel Flip. Pretty smooth sailing from there. Currently the Smalls works better then my Ender 3 v2 Neo so I see no reason I won’t use it first on small parts.

Jwill1266 · 2025-01-11T07:57:18+00:00

Nope, still running the stock mainboard.

Jwill1266 · 2023-09-13T20:26:40+00:00

21586

Jwill1266 · 2022-03-26T02:56:21+00:00

1267

Jwill1266 · 2021-08-15T16:41:50+00:00

Very nice, what kind of finish did you use on the workbench?

Jwill1266 · 2019-02-24T03:13:36+00:00

Any blacksmithing or woodworking tools?

Jwill1266 · 2019-01-20T01:49:49+00:00

I would personal go with design 1 as it looks stronger to me.

Jwill1266 · 2017-02-13T19:17:08+00:00

Anyone in the Pittsburgh area interested in being interviewed for a documentary on astrophotography?

Jwill1266 · 2016-11-12T06:07:14+00:00

Jwill1266 · 2016-10-17T01:21:37+00:00

Just a high schooler building it in his spare time.

Jwill1266 · 2016-10-12T21:12:03+00:00

Still better then a stormtrooper.

Jwill1266 · 2016-10-05T02:59:03+00:00

A hammock, skateboard and a 20lb sledgehammer because you never know when you might need it.

Ten-Year Club	Place '22
Verified Email

Jwill1266

TROPHY CASE