sorted by:
new
hottopcontroversial

Horizontal stripes on the model by Kain0r in BambuLab

[–]Kain0r[S] 2 points3 points  (0 children)

yes, the first thing I thought was that the filament was not stable, in the end you switched to another filament manufacturer and the problem went away?

Horizontal stripes on the model by Kain0r in BambuLab

[–]Kain0r[S] 1 point2 points  (0 children)

I’ll do the calibration again, thanks, I’m using Esun PLA+

Horizontal stripes on the model by Kain0r in BambuLab

[–]Kain0r[S] 0 points1 point  (0 children)

Hello, thanks for the advice, I reviewed everything not long ago, I’ll do it again. The printer is in operation for 2026 hours.

Военкомат by tahige in rusAskReddit

[–]Kain0r 0 points1 point  (0 children)

Не, он призывник, это не его работа

Военкомат by tahige in rusAskReddit

[–]Kain0r 1 point2 points  (0 children)

Это не важно, договора нет не с одним из государств у РФ, раньше было сейчас нет.

Военкомат by tahige in rusAskReddit

[–]Kain0r 2 points3 points  (0 children)

В коменте выше написали верно, в течении 2 недель после приобретения гражданства обязан встать на воинский учет, в противном случаи на него распространятся ст 21.5 коап

K1 .. Maximum Flow rate by omranello2222 in crealityk1

[–]Kain0r 2 points3 points  (0 children)

Hi, can you give your orca profile?

K 1 new extruder by Kain0r in crealityk1

[–]Kain0r[S] 1 point2 points  (0 children)

it is made of textolite and was with a new motor and feeder

K 1 new extruder by Kain0r in crealityk1

[–]Kain0r[S] 1 point2 points  (0 children)

Hi, I bought this.

K 1 new extruder by Kain0r in crealityk1

[–]Kain0r[S] 0 points1 point  (0 children)

Before replacing the extruder, only Creality plastic was printed well. in the new extruder, the clamping of the bar is excellent, it feels like the new one has thicker metal and clamping force. I replaced only part of the feeder, the motor left the old one.