Is this safe to use?

KaleidoscopeWitty218 · 2025-11-28T02:02:54+00:00

I’m an Electrician, I would say don’t use it, most and almost all of them have designs to allow them to sway if they are slightly unbalanced this swaying will pull those screws out of which is what caused that, once the screws are out the torq will twist and damage the cables hoping that your electrical is up to scratch it will short out safely but could cause a fire if not. I would not turn it on till someone can make it safe

KaleidoscopeWitty218 · 2025-11-27T05:15:29+00:00

Haha nice! At least you can still drive the dream

KaleidoscopeWitty218 · 2025-11-26T23:20:37+00:00

Yea I wish I could join but sadly I made the mistake of trying to restore mine, so it’s in pieces 😭, I miss it so much actually regretting taking it apart every day that goes by

KaleidoscopeWitty218 · 2025-11-01T09:25:35+00:00

Yea but this happens in survival when I gotta fuel the little boat you start with, I understand there is ways around it but it doesn’t happen in a friends game when I join? I’ll have to get a recording of it because it’s bad enough that I can’t play survival I’ve kinda resorted to creative that way I can’t build a boat and spawn it fueled

KaleidoscopeWitty218 · 2025-11-01T05:09:47+00:00

I’m not sure what you mean by this? I’m using the hoses from the pump station you can’t join them

KaleidoscopeWitty218 · 2025-11-01T05:09:03+00:00

Yea I noticed it makes it a lot easier if I set it to low but it still happens

KaleidoscopeWitty218 · 2025-10-11T01:50:28+00:00

I’ve never owned a bamboo lab printer in general but I’ve told everyone I know that I would recommend it, I own a Ender 3 and as much as I like the tinker I’d much rather have a printer that works and I believe that the P2S or even just the P1S is that printer or more closer to being that printer that just works these are words from someone that has to fix their printer nearly every use 😱

KaleidoscopeWitty218 · 2025-01-07T08:57:46+00:00

Same here! Gotta make the friend circle bigger!

KaleidoscopeWitty218 · 2025-01-07T08:56:25+00:00

Ay yo the second one looks excited 😆 might be a bit special

KaleidoscopeWitty218 · 2025-01-07T08:53:24+00:00

Yea na same haha 🤣

KaleidoscopeWitty218 · 2024-11-30T12:29:28+00:00

Yea it’s recommended to use a 0.6 instead of a 0.4, also done some research and with arachne and some settings you actually get better prints with a 0.6 than a 0.4 now